Minka Lavery 6813 8-3 4 in 100 W 3 Light Medium Vanity Installation Guide

Minka Lavery 6813 8-3 4 in 100 W 3 Light Medium Vanity

Product Information

The product is a wall mount light fixture with model number 6813. It is designed to be installed on the wall and provides lighting in a specific area. The fixture comes with a junction box for connecting the wires.

Product Usage Instructions

WARNING: Before starting the installation process, make sure to shut off the power at the fuse or circuit breaker to avoid any electrical accidents.

Preparation

1. Locate the fuse box or circuit breaker and shut off the power.

Installation Steps

1. Position the fixture on the wall with the desired orientation. The fixture must be mounted with the light facing upward.
2. Using appropriate tools, securely attach the fixture to the wall.
3. Locate the junction box on the wall near the fixture.
4. Remove the cover of the junction box.
5. Connect the fixture wires to the junction box wires. Ensure proper matching of positive (+) and negative (-) connections.
6. Securely tighten the wire connections using wire nuts or other suitable connectors.
7. Replace the cover of the junction box.

INSTALLATION INSTURCTION

PREPARATION Fig.1

1. Shut off the power at the fuse box or circuit breaker box. If necessary. Remove old fixture and all mounting hardware from wall junction box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to loose any small parts necessary for installation. MOUNTING THE FIXTURE (Fig.1)

3. Position the circular strap (B) through the fixing holes onto the wall and make marks, drill pilot holes for wood screws (C) into the wall, then insert the plastic anchor (A) into the holes.

4. Secure circular strap (B) to outlet box (not provided) with outlet screws (D), then secure the outlet box with wood screws (C) into plastic anchors (A) in the wall.
   NOTE: The holes of the circular strap with anchors must be upward.
   CONNECTING THE WIRES (Fig. 2)

5. Connect the fixture wires to the junction box wires as shown in Fig. 2. Make sure all wire connectors are secure and do not easily pull off with a slighttug. If there is no green ground wire from the junction box, connect the fixture ground wire to the circular strap with the green screw provided.

6. Tuck these wire connections neatly into the wall junction box. COMPLETING THE INSTALLATION

7. Raise the mounting base (E) allowing for the mounting screws (F) to protrude through the holes on the mounting base (E), and then secure with the screws (F) by wrench.

8. Place the glass (G) over the socket (H) and secure with the retaining ring (I).

9. Install the proper light bulbs for your fixtures.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)Return the power to the junction box and test the fixture. Your installation is now complete.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. For Wall Mount Light Fixtures  Return the power to the junction box and test the fixture. Your installation is now complete.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>