Minka Lavery 4510741 17-1 4 in 100W 2 Light Wall Sconce Installation Guide
- June 13, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 4510741 17-1 4 in 100W 2 Light Wall Sconce
Product Information
- Product Name: Fixture Installation Kit
- Model Number: Item #341
- Revision Date: 02/27/2012
- Manufacturer: [Manufacturer Name]
INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig. 1)
-
Shut off power at the circuit breaker and remove old fixture from ceiling, including the mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
-
Secure Circular Strap (B) using Screw (D) (Size: #8-32N*L0.5”) to the Outlet Box (A). The side of the Circular Strap marked “GND” must face out.
-
Screw Studs (C) into the screw hole of Circular Strap (B).
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s Ground Wire to it. Otherwise, connect the fixture’s Ground Wire directly to the crossbar using the Green Screw provided.
FINISHING THE INSTALLATION (Fig. 1) -
Place Fixture Body (F) into two Studs (C) and secure it tightly using Knurled Knobs (E).
-
Install the light bulb in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!). 8. Insert Glass Shade ( G ) into frame of the Fixture Body ( F ).
Your installation is now complete. Return power to the outlet box and test the
fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.