HAMRON 016040 Light Bar LED Instruction Manual
- June 4, 2024
- HAMRON
Table of Contents
HAMRON 016040 Light Bar LED Instruction Manual
SAFETY INSTRUCTIONS
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
SYMBOLS
| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
- Rated voltage: 9 —36 VDC
- Light source: 18 x5 W LED
- Output: 90 W
- Luminous flux: 8100 Im
- Colour temperature: 6000 K
- Range: 1 lux at 450 m
- Range: 0.25 lux at 900 m
- Protection rating: IP68
- Cord length: 50 cm
- E-approved: Yes
- *ETM:** Yes
- Size: W520 x H40.5 x D52.5 mm
- Weight: 1.45 kg
- Electronic thermal management
DESCRIPTION
Slim extra lighting that makes driving safer and less tiring. Hamron’s slim
light bar produces a more discrete impression and a stylish look. There are a
total of 18 x 5 W LED light sources that deliver 8100 theoretical lumen and
6885 actual lumen. The beam is a so-called Spot beam, which means that the
light bar produces a powerful spot beam a long way ahead on the road. LED
light sources have electronic thermal monitoring (ETM), which retains the
intensity of the diodes and avoids discolouring if the heat becomes excessive.
Adapter for fixed installation and mounted on the supplied bottom or side
fasteners made of stainless steel. Installation accessories and DT connector
included.
Fig.1
BEAM
- Diffusion angle
- Metres
FIG. 2
ETM
Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is maintained and discolouring is avoided if the heat becomes excessive.
INSTALLATION
- Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short-circuiting during the installation.
- Follow as far as possible the existing cable routing for installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
- Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
- The product can be mounted with side (1) or bottom (2) fasteners. Put the screws in the holes, put on the lock washers and tighten the nuts.
FIG. 3
Cable colour coding
The DT connector’s red wire is (+) and the black wire is (—).
WARNING!
- The product must only be used within its rated voltage range, 9 to 36 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
Care for the environment!
Recycle discarded product in accordance with local regulations.
Jula reserves the right to make changes. For latest version of operating
instructions, see www.jula.com
JULA AB, BOX 363, SE-532 24 SKARA
2022-02-23
© Jula AB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>