FORTIN 2004-2007 Chevrolet Colorado Standard-Key Remote Starters and Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
REGULAR INSTALLATION
ADDENDUM – SUGGESTED WIRING CONFIGURATION
Vehicle functions supported in this diagram (functional if equipped)
VEHICLE YEARS
CHEVROLET
AUTOMATIC TRANSMISSION ONLY
2004-2007
2004-2007 Chevrolet Colorado Standard-Key Remote Starters and Alarm
Systems
- PK3, Passlock
- Lock
- Unlock
- Arm
- Disarm
FIRMWARE VERSION 70.[18] ONLY – SEULEMENT
To add the firmware version and the options, use the FLASH LINK UPDATER or
FLASH LINK MOBILE tool, sold separately.
Program bypass option
IF THE VEHICLE IS NOT EQUIPPED WITH FUNCTIONAL HOOD PIN:
| UNIT OPTION | DESCRIPTION |
|---|---|
| A11 | Hood trigger (Output Status). |
MANDATORY INSTALL
* HOOD PIN
HOOD STATUS : THE HOOD PIN SWITCH MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE STARTED WITH THE HOOD OPEN, SET FUNCTION A11 TO OFF.
A11|
---|---
Notice: the installation of safety elements are mandatory. The hood pin
is an essential security element and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION
CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.
DESCRIPTION
WIRING CONNECTION
PROGRAMMING PROCEDURE
| Press and hold
the programming button:
Connect the 4-PIN Data-link harness (Black connector).
+The Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate.
---|---
| Release the
programming button when the LED is BLUE.
If the LED is not solid BLUE disconnect the 4-Pin connector (Data-Link) and go
back to step 1.
| Insert the
required remaining connectors.
| Turn the key
to the Ignition ON/RUN position.
+The BLUE LED will turn off.
+The RED LED will turn ON.
+The RED LED will flash.
| Start the
vehicle and hold at START position for 3 seconds
+The RED LED will turn off and the YELLOW LED will turn ON.
| Turn the key
to the OFF position.
+The LED will turn OFF.
The module is now programmed.
Module label
www.fortinbypass.com
Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest firmware
and download the latest installation guide(s) prior to the installation of
this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer safelogic probe or digital multimeter should
be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability
irresponsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualified technician. The information supplied is a guide
only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
Copyright © 2006-2018, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED PATENT PENDING
TECH SUPPORT
Tél: 514-255-HELP (4357)
1-877-336-7797
ADDENDUM GUIDE
www.fortinbypass.com
WEB UPDATE
This guide may change without notice. See
www.fortin.ca for latest version.
REV.: 20211105
Guide # 103191