Minka Lavery 2923-77-L 44W 1 Light Bath Light Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
FOR 2923-77-L
For LED Wall Mount Fixture
2923-77-L 44W 1 Light Bath Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box. If necessary remove the existing fixture and its mounting hardware.
-
Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration.
-
Position mounting plate (A) on the wall, and mark the location of the two drywall anchors (G). Pre-drill the holes for the drywall anchors (G) and insert the drywall anchors (G) into the wall.
-
Attach the mounting plate (A) to the junction box using junction box screws (B) (Size: 8-32*1/2’’L). The side of the mounting plate marked “GND” must face out.
-
Place the wood screws (F) through the holes of the mounting plate (A) and into the drywall anchors (G) to secure the mounting plate (A) to the wall.
CONNECTION THE WIRES (Fig. 2) -
At this point, connect the electrical wires as shown in Fig.2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground Wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided. After the wires are connected, tuck them carefully into the junction box.
FINISHING THE INSTALLATION (Fig. 1) -
Align Fixture (E) to mounting plate (A) and secure with screws (D).
-
Place glass shade (L) inside the fixture (E), and secure with screw (Q) steel washer (P) and plastic washer (O).
Your installation is now complete. Return power to the junction box and test
the fixture.
CAUTION /ATTENTION : When handling the fixture, do not apply pressure to
the LEDs. Hold the fixture by the base or fixture body (E) only.
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without cutting the
wires and without damaging the decorative element to which the fixture is
attached. See installation steps for more details (Fig 3.)
Warning: Turn off power at the fuse box or circuit breaker before replacing
LED module.
a. To remove the fixture from the wall: loosen screws (D) and remove the wire
connectors. Then place the fixture on a clear flat surface.
b. Loosen screw(Q) to remove the glass shade (L)
c. Loosen screws (R) to remove end caps (H) and glass shade (K).
d. Loosen screws (J), screws (M), wire fastener (N) and then carefully remove
LED module (I).
e. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure
proper wiring and installation.
Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type dimmers
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>