FORTIN EVO-START Smartphone Interface Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
EVO-START
GUIDE # 102151
INSTALL GUIDE
PARTS REQUIRED (NOT INCLUDED)
1X| EVO-ONE or
E400 or
EVO-ALL
---|---
| RFA2A (low power connector)
(For EVO-ALL)
| FLASH LINK UPDATER 4
OR
FLASH LINK MOBILE
| Microsoft Windows Computer & Internet connection
OR
Smartphone AndroId or iOS with Internet connection (provider charges may
apply).
WARNING
Neither the manufacturer or distributor of this module is responsible for
damages of any kind either indirectly or directly caused by this module,
except for the replacement of this module in case of manufacturing defects.
This module must be installed by a qualified technician. This instruction
guide may change without notice.
Visit WWW.FORTIN.CA or WWW.EVO-START.CA to obtain the latest version.
EVO-ONE INSTALLATION & PROGRAMMING
REMOTE STARTER FIRMWARE VERSION
1. [26] MINIMUM
WWW.FORTIN.CA| VISIT
WWW.FORTIN.CA
---|---
EVO-ONE| CHOOSE THE MODEL AND YEAR OF YOUR VEHICLE AND SELECT THE GUIDE FOR
EVO-ONE.
| OPTIONAL : A T-HARNESS FOR THE VEHICULE CAN BE AVAILABLE (SOLD SEPARATELY).
| DOWNLOAD THE INSTALLATION GUIDE FOR THE VEHICULE.
| CONNECT AND USE THE EVO-START WITH EVO-ONE CONNECTION (NEXT PAGE)
CONNECTION EVO-ONE INSTALLATION
EVO-ONE – ANTENNA PROGRAMMING
| DISCONNECT the evo start lte. (Connector A)
---|---
| CONNECT the rf kit antenna, if not connected. (connector B)
| PROGRAM the rf kit first following your specific rf kit installation guide
which can be found at fortin.ca.
| Once the rf kit is programmed DISCONNECT rf antenna from the module.
| CONNECT in the evo start lte. (Connector A).
| Turn the Ignition ON, you have 5 sec. to complete the step B:
| Turn the Ignition OFF.
| Turn the Ignition ON.
Press and release the brake pedal 4 times.
Once in pairing mode, EVOStart will automatically pair. Parking light will
flash once to confirm (if connected)
Turn the Ignition OFF to exit programming mode.
WITH RF KIT**
SOLD
SEPARATELY**
CONNECT the rf kit antenna.
(Connector B)
If this sequence is not followed, neither will work.
E400 INSTALLATION & PROGRAMMING
HARDWARE VERSION
REMOTE STARTER FIRMWARE VERSION
1. 26
MINIMUM
INSTALL WITH E400 ONLY:
MAKE THE CONNECTION AND PROGRAM THE E400 TO THE VEHICLE.
USE THE INSTALLATION GUIDE SUPPLIED WITH THE E400.
INSTALL WITH E400 & EVO-ALL:
WWW.FORTIN.CA| VISIT
WWW.FORTIN.CA
---|---
EVO-ALL| CHOOSE THE MODEL AND YEAR OF YOUR VEHICLE AND SELECT THE GUIDE FOR
EVO-ALL.
| DOWNLOAD THE EVO-ALL INSTALLATION GUIDE FOR THE VEHICULE.
| MAKE THE DATA-LINK CONNECTION AND PROGRAM THE EVO-ALL AND THE E400 TO THE
VEHICLE.
CONNECTION 1 – E400 INSTALLATION
HIGH POWER CONNECTIONS
(more than 3AMP required for E400 operation)
DIAGNOSTICSD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>