MINKA LAVERY 5615-695-L Boada 1-Light 18 Inch Soft Brass LED Semi Flush Mount Light Installation Guide
- June 13, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
For item# 5615-695-L (New. 2023/02/16)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
Fig. 1
Set#A-021-143DA
– Mounting Plate
– Ground Screw
– Mounting Screw *2
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a clean
area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig.1)
3. Remove screws (D) on mounting plate (A) from fixture’s body (C).
4. Secure mounting plate (A) to junction box (not included) using mounting
screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate (A) marked
with “GND” and two convex points must face out.
5. The support cable is provided to support weight of fixture while wiring.
Align fixture to mounting plate (A) and attach hook (F) on the end of support
cable (E) to a slot located on mounting plate (A). Carefully allow support
cable (E) to support weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in (Fig.2). Making sure that all
wire connectors are secured. If your junction box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it. Otherwise, connect
fixture’s ground wire directly to mounting plate (A) using green screw
provided.
7. Tuck wire connectors neatly into the junction box.
Fig. 2
- FIXTURE WIRES Black or Smooth
- HOUSE WIRES Black (Hot)
- FIXTURE WIRES White or Ribbed
- HOUSE WIRES White (Neutral)
- FIXTURE WIRES Bare Copper (Ground)
- HOUSE WIRES Green (Ground)
COMPLETING THE INSTALLATION (Fig. 1)
8. Place canopy (C) over mounting plate (A) and secure with screws (D).
Note: The LED module should be provided by a specified supplier.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
LA-3649E
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>