Minka Lavery 5046-695 Bungalow Heaven 6 Light Soft Brass Pendant Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 5046-695 Bungalow Heaven 6 Light Soft Brass Pendant
MOUNTING THE FIXTURE (Fig.1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
- Secure Rod (E) onto all thread (G) on the light cluster.
- Place medium shade (K) on small shade (N) and secure with screws (J). Place large shade (I) on medium shade (K) and secure with screws (J). Place large shade (I) over all thread on rod (E).
- Determine the desired hanging height and thread rods (F1, F2 and F3) to the all thread on top of rod (E). Attach canopy (C) onto rod (F1). Carefully feed wires through each rod as you assemble.
- Attach mounting plate (A) to junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate (A) marked “GND” and two convex points must face out.
- The support cable is provided to support weight of the fixture while wiring. Align fixture to mounting plate (A) and attach hook (P) on the end of support cable (O) to a slot located on mounting plate (A). Carefully allow support cable (O) to support weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
- Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
- Tuck wire connectors neatly into the junction box.
FINISHING THE INSTALLATION (Fig.1)
- Place canopy (C) over mounting plate (A) and secure with screws (D).
- Place candle covers (L) over sockets (M).
- Install (6) six candelabra base bulbs (H) up to 60 watts each or CFL or LED equivalent (not included), in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only.
It may or may not be identical to the fixture purchased
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>