IKEA 105.208.06 MITTLED LED Kitchen Worktop Lighting Strip Instructions
- October 30, 2023
- Ikea
Table of Contents
IKEA 105.208.06 MITTLED LED Kitchen Worktop Lighting Strip
Product Information
The product is called “MITTLED” and is designed for indoor use only. It uses nonchangeable light diodes (LED) as its light source and should not be disassembled as it can cause damage to the eyes. The product should not be immersed in water. The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W. The maximum number of units that can be used together is 10. The LED driver and power supply cord are sold separately.
Product Usage Instructions
- Before using the product, check the cord, transformer, and all other parts for damage. If any part is damaged, do not use the product.
- Mount the product only on a surface that is mechanically sound to avoid injury to persons and damage to the lamp and/or the mounting surface.
- Use only IKEA LED drivers suited for this product.
- The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W.
- The maximum number of units that can be used together is 10.
- Clean the product using a damp cloth. Never use a strong cleaning agent.
- Keep these instructions for future use.
IMPORTANT SAFETY INSTRUCTIONS
For indoor use only.
Regularly check the cord, the transformer and all other parts for damage. If
any part is damaged the product should not be used. Important information!
Keep these instructions for future use.
CAUTION!
- The light source of this product is nonchangeable light diodes (LED).
- Do not disassemble the product, as the
- light diodes can cause damage to the eyes.
- Do not immerse in water.
Cleaning
Use a damp cloth, never a strong cleaning agent.
CAUTION
To reduce the risk of fire, electric shock, or injury to persons: Use only
insulated staples or plastic ties to secure cords. Route and secure cords so
that they will not be pinched or damaged when the cabinet is pushed to the
wall. Position the portable cabinet light with respect to the cabinet so the
lamp replacement markings can be read during relamping. Not intended for
recessed installation in ceilings, or soffits. The low-voltage portable
cabinet light may be installed inside or under a kitchen cabinet or other
built-in furniture when:
- The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
- The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or floors. This requirement does not apply to the wiring between the cabinet light and the power unit. The National Electric Code (NEC) does not permit cords to be concealedwhere damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it maybe inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.
ATTENTION:
CAUTION:
Injury to persons and damage to the lamp and/or the mounting surface may
result if the lamp is pulled from the surface. To reduce the likelihood of
such injury or damage, mount only on a surface that is mechanically sound.
Use only IKEA LED drivers suited for this product. The total wattage of the
lamps connected to one LED driver must not exceed the maximum power stated on
that LED driver and never more than 30W
WARNING
Deviation from the assembly instructions may result in a risk of fire or
electric shock.
TOOLS NEEDED
HELP
WHATS INSIDE
INSTRUCTIONS
Max 10 units.
STEPS
© Inter IKEA Systems B.V. 2021