Minka Lavery 5045-695 Heaven 5 Light Soft Brass Pendant with Papyrus Rope Shade Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
Item#5045-695 (New. 2023/02/27)
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
-
Shut off power at the fuse box or circuit breaker box andremove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the partsin a clean area. Take care not to misplace any small partsnecessary for installation.
-
Secure rod (E) onto all thread (G) on the light cluster.
-
Place large shade (I) on small shade (K) and secure withscrews (J). Place large shade (I) over all thread on rod (E).
-
Determine the desired hanging height and thread rods (F1,F2 and F3) to the all thread on top of rod (E). Attachcanopy (C) onto rod (F1). Carefully feed wires througheach rod as you assemble.
-
Attach mounting plate (A) to junction box (not included)with mounting screws (B) (Size: #8-32N*L0.5”). The side ofthe mounting plate (A) marked “GND” and two convexpoints must face out.
-
The support cable is provided to support weight of thefixture while wiring. Align fixture to mounting plate (A) andattach hook (P) on the end of support cable (O) to a slotlocated on mounting plate (A). Carefully allow supportcable (O) to support weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in fig 2, making surethat all wire connectors are secured. If your junction boxhas a ground wire (green or bare copper), connect thefixture’s ground wire to it. Otherwise, connect the fixture’sground wire directly to the mounting plate (A) using thegreen screw provided.
-
Tuck wire connectors neatly into the junction box.
FINISHING THE INSTALLATION (Fig.1) -
Place canopy (C) over mounting plate (A) and securewith screws (D).
-
Place candle covers (L) over sockets (M).
-
Install (5) five candelabra base bulbs (H) up to 60 wattseach or CFL or LED equivalent (not included), inaccordance with the fixture specification—DO NOTEXCEED THE MAXIMUM WATTAGE RATING! (NE PASDEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased
LA-3652E
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>