Decaura 8557 Square Rain Shower Set Instruction Manual

Decaura 8557 Square Rain Shower Set

Square Rain Shower Set

• For Model Code: 8557, 8557-2, 8557-3, 8557-4 (In different shower heads only)

Dimension

Parts

Spare Parts :
15| MS Grab Screws| X4
16| Spare Shower Hose Rubber Washer| X1
17| Spare 0-Rings For Upper Pipe| X3
18| Spare 0-Rings For Connector| X3

Instructions

1. Working pressure: 0.05-1 MP, Working temperature: 0-55 °C.
2. Products are manufactured as per standard AS/NZS 3662:2005. as per Australian standard, and with Watermark & WELS certificate as shown in the packing.
3. All surfaces should be cleaned with water or mild liquid detergent. Do not use cream cleaner or citrus based or chemical cleaning products.

Warranty Terms

All products are guaranteed as below:

1. 5 years guarantee against main body. finishing and Cartridge.
2. 2 years guarantee on washers and 0-rings.

Installation Steps

Put the sliding bracket from top of nether pipe. Unscrew 2 grab screws located at the rear of the nether pipe, then plug the upper pipe and nether pipe together and tighten firmly by 2 grab screws.

Install The Rail

Very Important:

1. Smear the grease oil 14 on the connector 0-rings.
   Don’t wrap Teflon tape over the 0-rings.

2. To avoid connector 0-rings scratched by screw tip and causing water leakage, the screws must be loosed enough before plug the main body onto the connector.

3. Unscrew the nether pipe holder by big alien key, adjust holder to proper position and fix it firmly by big alien key. Gently plug the holder onto the mounting nut and tighten it by 2 bottom grab screws.
   

Make sure washers and flow restrictor as shown inside shower rose. Screw shower rose to arm.

Make sure washer as shown inside shower hose.
Please note that the conical nut should be connected to handheld shower , the hex nut should be connected to shower rail.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>