FORTIN 97321 2020 Ford Transit Keyless-Std Remote Starters and Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
FORTIN 97321 2020 Ford Transit Keyless-Std Remote Starters and Alarm
Systems Installation Guide
VEHICLE VEHICULES FORD
Transit
NOTES
ATTENTION THE T-HARNESS CURRENT IS LIMITED| ATTENTION LE COURANT DU 12V
PROVENANT DU HARNAIS-
AT 10 AMP MAXIMUM.| EN-T EST LIMITÉ À 10 AMPÈRES MAXIMUM.
If a parking lights (+) wire is use : they require more| Si le fil des
lumières de stationnement (+) est utilisé: il requière
than 10Amp. Connect the remote-starter’s power| plus de 10 Ampères, branchez
le 12V du démarreur à distance
directly to the vehicles battery with the appropriate fuse.| directement à la
batterie du véhicule avec le fusible approprié.
Some remote starters can not be powered through| Certains démarreurs à
distance NE peuvent PAS être allimentés
Data-Link. In these cases connect the remote starter’s| par le Data-Link. Dans
ce cas, branchez le 12V (avec fusible) du
fused 12V power wire directly to the T-Harness.| démarreur à distance
directement au harnais-en-T.
DESCRIPTION | DESCRIPTION
WIRING CONNECTION | GUIDE DE BRANCHEMENTS
THAR-FOR2 WIRING CONNECTION | GUIDE DE BRANCHEMENTS
DCRYPTOR PROGRAMMING PROCEDURE | PROCÉDURE DE PROGRAMMATION AVEC DCRYPTOR
Notice: Updated Firmware and Installation Guides
Updated fi rmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest firmware
and download the latest installation guide(s) prior to the installation of
this product. Notice: Mise à jour microprogramme et Guides d’installations
Des mises à jour du Firmware (microprogramme) et des guides d’installation
sont mis en ligne régulièrement. Vérifiez que vous avez bien la dernière
WARNING
The information on this sheet is provided on an (as is) basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly or any other way. Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be installed by qualified technician. The information supplied is a guide only. This instruction guide may change without notice. Visit www.fortinbypass.com to get the latest version.