FORTIN 85741 2021 Kia Telluride Push Button Remote Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
REV.: 20220222
GUIDE # 85741
REGULAR INSTALLATION
ADDENDUM – SUGGESTED WIRING CONFIGURATION
85741 2021 Kia Telluride Push Button Remote
Vehicle functions supported in this diagram (functional if equipped
| VEHICLE | YEARS |
|---|
KIA
Telluride
Push-to-Start
2020-2022
Automatic transmission
| To add the firmware version and the options, use the FLASH LINK UPDATER or
FLASH LINK MOBILE tool, sold separately.
---|---
| Parts required (Not included)
1X Fuse
DESCRIPTION
WIRING CONNECTION
PROGRAMMING PROCEDURE
| Press and hold Insert the programming button:
the 4-Pin (Data-Link Connector) connector.
The LED will alternate between YELLOW and RED.
---|---
| Release the programming
button when the LED is RED.
If the LED is not solid RED disconnect the 4 Pin connector (Data-Link
Connector) and go back to step 1.
| Insert the required remaining connectors.
| Press and release the programming button 6 times (6x).
The RED LED will flash 5 times and pause.
| The RED LED will flash rapidly 10x times.
Key bypass programmed.
Do not press the brake pedal.
Press the START/STOP button twice to turn ON the ignition.
| Press the START/STOP button once to turn OFF the ignition.
The module is now programmed.
Use the remote of the remote starter or security system to test all of the
supported features to ensure proper programming.
Notice: Updated Firmware and Installation Guides
Updated fi rmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest fi rmware
and download the latest installation guide(s) prior to the installation of
this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever.
It is the sole responsibility of the installer to check and verify any circuit
before connecting to it. Only a computer safe logic probe or digital
multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no
liability or responsibility whatsoever pertaining to the accuracy or currency
of the information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualifi ed technician. The information supplied is a guide
only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
TECH SUPPORT
Tél: 514-255-HELP (4357)
1-877-336-7797
ADDENDUM GUIDE
www.fortinbypass.com
WEB UPDATE