CHORS Thiny Snake K Surface Mounted Ceiling Light Instruction Manual
- June 12, 2024
- CHORS
Table of Contents
CHORS Thiny Snake K Surface Mounted Ceiling Light
MOUNTING HOLES
Thiny Snake K 60 22.2111.xxx.xxx
| W | X | Y |
|---|---|---|
| 100 mm | 97 mm | 187 mm |
Thiny Snake K 90 22.2112.xxx.xxx
| W | X | Y |
|---|---|---|
| 100 mm | 250 mm | 490 mm |
Thiny Snake K 120 22.2113.xxx.xxx
| W | X | Y |
|---|---|---|
| 100 mm | 250 mm | 490 mm |
Thiny Snake K 150 22.2114.xxx.xxx
| W | X | Y |
|---|---|---|
| 200 mm | 350 mm | 790 mm |
ELECTRICAL WIRING DIAGRAMS
ON/OFF 22.21XX.JXX.XXX
DALI 22.21XX.TXX.XXX
ASSEMBLY INSTRUCTIONS
-
Turn o the power
-
Attach the screws (A) and dowels (mounting holes scheme on the other side of the page)
-
Fasten the lamp to the wall with screws (A). Use the SW 5.5 ring wrench.
-
Connect the 230V power to the driver. Remember to ground (electrical wiring diagrams on the other side of the page).
-
Push the strip with the LED module into the housing. Make sure that the bar is placed parallel to the housing. Be careful not to crush the LEDs. In order to disassemble the reflector, lift the strip with a flat screwdriver at the milling point, leaning the tool against the protected edge of the housing.
-
Install the diffuser in the luminaire:
1. Half the length of the lamp press the end of the diffuser to profile, and then insert.
2. Press the other end of the diffuser To pull out, gently pry with a plastic object and push out. -
Turn on the power.
The enclosed tool kit is designed for solid materials (solid brick, wood, concrete, aerated concrete) and gypsum board surfaces. The dowel should be properly matched to the mounting surface. Proper use of the dowel a ects the safety and strength of the structure.
TOOLS
CUSTOMERS SUPPORT
SOŁTYSOWICKA 19C | 51-168 WROCŁAW | POLAND
T: +48 71 323 14 00-01 | W: CHORS.PL
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>