BEGA 50713.2 LED Recessed Ceiling Luminaire Instruction Manual

Table of Contents

BEGA-50713-2-LED-Recessed-Ceiling-Luminaire-FIG-1

Application

Pivoting recessed ceiling luminaire · indoor luminaire partially satin matt crystal glass inside and aluminium alloy housing.
Efficient luminaires for adjustable, brilliant light in the residential living space and for use in many other ranges of interior illumination.
For installation into ceilings with a shallow depth in interior areas.

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Lamp

50 713.2 K27

50 713.2 K3

The recessed opening will be covered by the attachement of the installation ring.
Fixing of the luminaire is achieved by using 2 adjustable claws.
LEDs are high-quality electronic components!
Please avoid touching them directly during installation or relamping.

Installation into false ceilings

A recessed opening of Ø 95 mm is necessary to accept the luminaire housing. Free space depth min. 60 mm.
The claws catch the panel from the reverse side.
If minimum thickness of the panel is less than 3 mm it must be reinforced from the reverse side.
Maximum thickness of the panel must be no more than 20 mm.
The notch in the installation ring indicates the direction of maximum pivoting range (35°) of the luminaire housing.
Remove glass with reflector from luminaire housing by turning counter-clockwise.
The electrical connection must be made on site in the appropriate safety class on the LED power supply unit connecting cable. A distribution box must be used.
Ensure the correct assignment of the connecting cable. Establish the mains connection on the brown (L) and blue (N) wires.
Push external LED-power supply unit and luminaire housing into ceiling cut-out.
Hand-tight screws of claw fasteners evenly.
Insert glass with mounted reflector by turning it clockwise into luminaire housing.
Make sure that gasket is positioned correctly.
Mount ceiling frame ring (magnetic) onto installation ring of the housing.

Replacement of the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools.
Disconnect from main supply.
Remove glass with reflector from housing by turning it counter-clockwise.
Pull ceiling frame ring off the installation ring of the pivoting housing.
Please follow the installation instructions for the LED module.
Check gasket. Screw in glass with mounted reflector by turning it clockwise into luminaire housing.
Mount ceiling frame ring onto installation ring of the housing.
Defective glass must be replaced.

Spares