Abni s Lighting 22533 Wall Mount LED Light Instruction Manual
- June 13, 2024
- Abni s Lighting
Table of Contents
Abni s Lighting 22533 Wall Mount LED Light
CAUTION
Inspect the wire insulation for any cuts, abrasions, or exposed copper that
may have resulted during shipping. If there is a defect in the wire, do not
attempt installation.
Before starting installation of this fixture or removal of a previous fixture,
disconnect the power by turning off the circuit breaker or by removing the
fuse at the fuse box.
TOOLS REQUIRED
-
Ladder
-
Safety glasses
-
Electrical tape
-
Phillips screwdriver
-
Flat blade screwdriver
-
Pliers
-
Wire strippers
PARTS
-
Fixture
-
SHADE
-
Cap Nuts
-
Mounting Screws
-
Wire Nuts
-
Mounting Unit
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Assembly Instructions
MODEL#:22533
STEP 1 Use the mounting screws to attach the mounting unit to the
junction box
STEP 2 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw.Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round & smooth) or Black Fixture Wire to:
Connect Clear, Brown, Gold or Black *Parallel Wire with tracer (square & ridged) or White Fixture Wire to:
Black or Red Supply Wire or Insulated Wire (other than green) with copper conductor.
White Supply Wire or Insulated Wire (other than green) with silver conducto
STEP3 Place the canopy over the mounting unit and secure the fixture with the cap nuts.
STEP4 Unscrew the lamp holder ring
STEP5 Install the lampshade
STEP6 Install bulb(Not Included) E26 TYPE A 60W*3
