BEGA 24070 Wall Luminaire Instruction Manual

: June 12, 2024
: BEGA

Table of Contents

24070 Wall Luminaire
Safety
Overvoltage protection
Installation
Cleaning · Maintenance
Replacing the LED module
Spares
Documents / Resources

Wall luminaire
24 070

24070 Wall Luminaire

BEGA 24070 Wall Luminaire - fixing screws

Instructions for use

Application
Shielded wall luminiaire with high protection class.
A luminaire made of aluminium alloy and crystal glass.

Product description
Luminaire made of aluminium alloy,
aluminium and stainless steel
BEGA Unidure® coating technology
Colour graphite or silver
Crystal glass, white inside
2 mounting holes ø 6 mm
Distance apart 180 mm
2 cable entries for through-wiring of mains supply cable ø 7-10.5 mm
Connection terminal 2.5◻
Earth conductor connection
LED power supply unit
220-240 V ≂ 0/50-60 Hz
DC 170-280 V
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
Protection class IP 65
Dust-tight and protection against water jets
Impact strength IK07
Protection against mechanical impacts < 2 joule
– Safety mark
– Conformity mark
Weight: 3.2 kg
This product contains light sources of energy efficiency class(es) C, D

Safety

The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Installation

LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.
Take note of the cover frame fixing screw positions when installing the luminaire base (see sketch).
Undo screws.
Remove luminaire top and glass.
Undo screws key slots and remove the LEDunit.
Disconnect plug connection.
Lead the mains supply cable through the cable entry of the luminaire base.
Fix luminaire base with enclosed or any other suitable fixing material onto the mounting surface.
Be sure to use the gasket rings supplied. In order to guarantee the maximum service life of the electrical components, the enclosed desiccant pouch must be placed in the luminaire.
Remove the desiccant pouch from the foil packaging and place it in the position marked by the red information label immediately before finally closing the luminaire.
Make the earth conductor connection and the electrical connection.
Push plug into coupler as far as it will go.
Reassemble LED-unit and tighten fixing screws firmly and evenly. Please observe that the LED board is not damaged mechanically.

BEGA 24070 Wall Luminaire - board

Make sure that gasket is positioned correctly. Install the luminaire top with glass (as displayed in the sketch), press-on and tighten screws evenly.

Lamp

Cleaning · Maintenance

Clean luminaire regularly with solvent-free cleansers from dirt and deposits.
Do not use high pressure cleaners.

Replacing the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire gaskets.
Defective glass must be replaced.
Close the luminaire.