BEGA 51205.5 LED Pendant Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 51205.5 LED Pendant Luminaire Instruction Manual
System pendant luminaire for indoor use
Instructions for use
Application
Ceiling luminaire downlight · indoor luminaire with broad spread light
distribution.
BEGA Hybrid Optics® : Highly efficient and lowloss light distribution, thanks
to reflector and optical lens.
BEGA System pendant luminaire for use in combination with various modular BEGA
installation components.
Product description
- Pendant luminaire downlight
- Cast aluminium luminaire housing, finish Colour velvet black,
- Reflector surface made of pure aluminium
- Optical silicone lens · BEGA Hybrid Optics®
- Trim ring · Chrome finish
- Clear safety glass
- Black flex suspension 2 x 0,5@
- Overall length of luminaire approx. 1500mm
- Safety class III 3 c –
- Conformity mark
- Weight: 0.75 kg
- This product contains light sources of energy efficiency class(es) F
- Luminaire without canopy, for connection to an additional required
- BEGA Installation component (accessory)
Lamp
- Module connected wattage: 11.1 W
- Luminaire connected wattage: 14 W
- Rated temperature: ta=25 °C
- Ambient temperature ta: max=40 °C
51 205.5K3
- Module designation: LED-1150/930
- Colour temperature: 3000 K
- Colour rendering index: CRI > 90
- Module luminous flux : 1305 lm
- Luminaire luminous flux: 1148 lm
- Luminaire luminous efficiency: 82 lm/W
Lighting technology
Half beam angle 55°
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Please note:
The luminaire can only be operated with an operating device that fulfills
the requirements according to EN 61347-2-13. The maximum idle voltage of 60 V
DC must conform to SELV or SELV equivalent.
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping.
Screw enclosed trim ring with attached reflector into the luminaire housing by turning it clockwise.
To operate this luminaire one of the following additional BEGA Installation components must be ordered – accessoire.
Please refer to the instructions for use for the BEGA installation component selected for luminaire installation
Please note:
The manufacturer accepts no liability for damage caused by improper use or
installation if no BEGA installation component is used to install this BEGA
system pendant luminaire.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Replacing the LED module
- The designation of the LED module is noted on a label in the luminaire.
- The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified person using commercially available tools.
- Disconnect the system and open the luminaire.
- Please follow the installation instructions for the
- LED module.
- Close the luminaire.
Accessories
BEGA Installation components with LED power supply unit. Satin black finish
Depending on the desired type of installation, the following suitable installation components are available for this BEGA system pendant luminaire:
For all level ceilings:
13 228: Surface-mounted canopy (Type A) on/off · 220-240 V · 350 mA DC
13 281: Surface-mounted canopy (Type AS) Smart controllable / dimmable ·
220-240 V · 340 mA DC
Suitable for level ceilings and sloped ceilings with a pitch of 0 – 40°:
13 231: Surface-mounted canopy (Type B) on/off · 220-240 V · 350 mA DC
13 234 : Recessed canopy (Type C) on/off · 220-240 V · 350 mA DC
13 284: Recessed canopy (Type CS) Smart controllable / dimmable · 220-240
V · 350 mA DC
For flush and surface-mounted 3-phase Eurostandard-Plus® track systems:
13 221: Track adapter (Type D) on/off · 220-240 V · 350 mA DC
For the accessories a separate instructions for use can be provided upon request.
Spares
- LED module 3000 K: LED-1150/930
- Reflector : 75 003 685
- Glass/Trim ring: 75 003 796
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com