iskydance LV 0-1-10V LED Dimming Driver Owner’s Manual
- June 12, 2024
- iskydance
Table of Contents
0/1-10V LED Dimming Driver
Model No.: LV 0-10V or 1-10V signal input / Four PWM frequencies /
Logarithmic dimming
Features
- 1 channel 0/1-10V input, 1 channel PWM constant voltage output.
- 0~100% dimming range via logarithmic characteristic can be very comfortable for human eyes.
- Compatible with active or passive 0-10V, 1-10V dimmer, can solve the
- PWM frequency 500Hz, 2KHz, 8KHz or 16KHz selectable.
Technical Parameters
Input and Output
Input voltage| 12-48VDC
Input current| 8.5A
Output voltage| 12-48VDC
Output current| 1CH,8A
Output power| 96W/192W/288W/384W (12V/24V/36V/48V)
Output type| Constant voltage
Weight
Net weight| 0.043kg
Gross weight| 0.053kg
Dimming data
Input signal| 0/1-10V
Dimming range| 0-100%
Dimming curve| Logarithmic
PWM Frequency| 500Hz,2KHz,8KHz,16KHz
Warranty and Protection
Warranty| 5 years
Protection| Reverse polarity
Short circuit
Over-heat
Over-load
Safety and EMC
EMC standard(EMC)| ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Safety standard(LVD)| EN 62368-1:2020+A11:2020
Certification| CE,EMC,LVD
Environment
Operation temperature| Ta: -20 °C ~ +55 °C
Case temperature(Max.)| Tc: +85 °C
IP rating| IP20
Mechanical Structures and Installations
Wiring Diagram
Notes:
- The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.
- Compliant with 0-10V, 1-10V, 10V PWM, RX(4 in 1).
- We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 50 pieces, The maximum length of the wires from dimmer to LED driver should be no more than 50 meters.
Dimming Curve
PWM frequency setting
Long press SET key for 2s, set PWM frequency to 500Hz, LED indicator flashes
once.
Long press SET key for 5s, set PWM frequency to 2KHz, LED indicator flashes
twice.
Long press SET key for 10s, set PWM frequency to 8KHz, LED indicator flashes 3
times.
Long press SET key for 15s, set PWM frequency to 16KHz, LED indicator flashes
4 times.
Higher PWM frequency, will cause lower output current, higher power noise,
but more suitable for camera(No flickers for video).
User Manual Ver 1.0.8
Documents / Resources
|
iskydance LV 0-1-10V LED Dimming
Driver
[pdf] Owner's Manual
LV 0-1-10V LED Dimming Driver, LV, 0-1-10V LED Dimming Driver, LED Dimming
Driver, Dimming Driver, Driver
---|---