iskydance R15 1-Zone 4-Zone RGB RF Remote Controller User Manual
- June 4, 2024
- iskydance
Table of Contents
iskydance R15 1-Zone 4-Zone RGB RF Remote Controller User Manual
1 and 4 zone RGB /Touch color wheel/Wireless remote 30m distance/CR2032 battery
Features
- Apply to RGB LED controller, dimming driver or smart lamp.
- Ultra sensitive color adjustment touch wheel.
- Adopt 2.4GHz wireless technology, remote distance up to 30m.
- Each remote can match one or more receiver.
- Battery powered (CR2032).
- Operate with LED indicator light.
Technical Parameters
Mechanical Structures and Installations
To fix the remote, two options are offered for selection:
Option 1:
fix the remote’ back holder on the wall with two screws.
Option 2:
adhere the remote’ back holder to the wall with paster.
Note: Before the first use, please remove the protective film on the battery.
Note: If the LED indicator is not on when press key, it is due to dead battery or bad contact caused by multiple plugging, please replace the battery, or raise the battery shrapnel with a screwdriver.
Operation
- When light is on, touch the color wheel, the indicator will display red.
- To extend battery life, no touch or press key operation after a few seconds, the touch wheel will enter sleep state, you need press any key to make touch wheel quit sleep state.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Key function
R15: 1 zone RGB remote
On/Off: Turn on/off light.
Color wheel: Touch to change static RGB color.
R/G/B: Get red, green or blue color directly.
Mode+/-: Short press run the next or previous dynamic mode, long press
Mode+ 2s run mode cycle.
Speed+/-: For dynamic mode, adjust speed, short press 10 levels, long
press 2s get the fastest or slowest speed.
For static color, adjust saturation, namely change current static color to
mixed white slowly, short press 11 levels, long press for continuous
adjustment.
Brightness+/-: Adjust brightness, short press 10 levels, long press for
continuous adjustment.
R16: 4 zone RGB remote
On/Off: Short press turn on/off all zone light.
1,2,3,4 zone: Short press select and turn on zone light,
long press 2s turn off zone light.
short press multiple zone key fastly,
will select multiple zone synchronously.
Color wheel: Touch to change current zone static RGB color.
Mode: Short press run the next dynamic mode,
long press 2s run mode cycle.
Brightness+/-: Adjust brightness,
short press 10 levels, long press for continuous adjustment.
Speed: For dynamic mode, adjust speed,
short press 10 levels, long press 2s get the default speed.
For static color, adjust saturation, namely change current static color to
mixed white slowly, short press 11 levels, long press for continuous
adjustment.
Scene: One scene memory, short press recall the scene, long press 2s save
the current color into the scene. 4 zone recall or save synchronously.
Safety information
-
Read all instructions carefully before you begin . this installation.
-
When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery. -
If no response from the receiver, please re-match the remote.
-
Gently handle remote, beware of falling.
-
For indoor and dry location use only.
Read More About This Manual & Download PDF: