BEGA 31 208 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 31 208 Wall Luminaire Instruction Manual
Instructions for use
Application
Shielded wall luminaire made of copper and hand-blown crystal bubble glass.
The copper shield screens the luminaire to the front and produces an
impressive light distribution directed upwards and downwards.
Product description
Luminaire made of copper,
brass and stainless steel
Crystal bubble glass with screw neck
Silicone gasket
2 mounting holes ø 5.5mm
Distance apart 79mm
2 cable entries for through-wiring of mains
supply cable ø 7-10.5mm
Connecting terminal 2.5@
with plug connection
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 64
Dust-tight and protection against splash water
Weight: 3.0 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Light technique
If clear lamps are used, the brilliant impression created by the crystal
bubble glass is also transferred to the installation surface. Matt lamps
produce soft light distribution on the installation surface.
Lamp
Luminaire with screw base E 27
Lamp output max. 75 W
This product contains light sources of energy efficiency classes E, F
Supplied lamp
BEGA LED lamp 13587
LED Retrofit 8 W · 1055 lm · 3000 K
Luminaire efficiency: 30%
Additional BEGA LED lamps are available for this luminaire:
13 583 LED 7 W · 805 lm · 3000 K
13 585 LED 7 W · 805 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
The protective gloves enclosed are to be used during installation in order to
avoid fingerprints on the luminaire.
Undo fixing screws of the copper shield and remove copper shield.
Screw out glass from the base.
Undo screws and disassemble the luminaire housing from the mounting plate –
key slots –.
Lead the mains supply cable through the cable entry of the mounting plate.
Fix the mounting plate with enclosed or any other suitable fixing material
onto the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection to the
terminal – plug connection.
Push plug into coupler up to the stop.
Place the luminaire housing onto the mounting plate and fix with screws.
Insert lamp.
Screw glass with gasket into the luminaire housing.
Place on copper shield and fix it.
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary.
Close the luminaire.
For cleaning, do not use high pressure cleaners.
Copper
The luminaire parts made of solid copper are delivered with the metal’s
natural surface colour.
Time and weather factors create the natural patina characteristic for copper.
Spares
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · [email protected] · www.bega.com