Maxxima MRL-S38PLATE-10 Slim Downlight Metal Rough In Plate Installation Guide
- June 12, 2024
- Maxxima
Table of Contents
Maxxima MRL-S38PLATE-10 Slim Downlight Metal Rough In Plate
Product Information
Product Name: New Construction Downlight Metal Plate Installation Guide
Model Number: MRL-S38PLATE-10
Manufacturer: Maxxima
Website: www.maxximastyle.com
Warranty: 1 Year Limited Warranty
Contact Information:
- Email: info@maxximastyle.com
- Phone: 866-MAXXIMA (629-9462)
- Address: 125 Cabot Court Hauppauge, NY 11788
Product Usage Instructions
- Before starting installation, ensure that the power has been switched off.
- Secure the construction plate to the ceiling joists using the provided nails shown in Figure 1.
- Adjust the location of the metal plate by sliding it along its rails until the desired location is achieved.
- Tighten the screw on the side of the construction plate until the plate can no longer slide, as shown in Figure 2.
- If the light fixture being installed has a cutout greater than 3, remove the appropriate ring(s).
- If the light fixture has a cutout of 3, no rings need to be removed. If the cutout is 4, remove the appropriate ring(s), as shown in Figure 3 and Figure 4.
Please refer to the user manual or contact Maxxima for any further assistance or warranty claims.
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation, please consult an electrician.
CAUTIONS
- To ensure personal safety, proper grounding of the electrical fixture is required.
- The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.
MOUNTING INSTRUCTIONS
- Ensure power has been switched off before starting installation.
- Secure the construction plate to the ceiling joists using the provided nails shown in figure 1.
- Adjust the location of the metal plate by sliding it along its rails until the desired location is achieved. Then tighten the screw on the side of the construction plate until the plate can no longer slide shown in figure 2.
- If the light fixture being installed has a cutout greater than 3” then the appropriate ring(s) will have to be removed.
- If the light fixture has a cutout of 3” then no rings will have to be removed. If the light fixture has a cutout of 4” then the innermost ring will have to be removed. If the light fixture has a cutout of 6” then the two innermost rings will have to be removed. If the light fixture has a cutout of 8” then all of the rings must be removed.
- After the correct size is selected, install the ceiling material of choice (not suplied) and ensure the cutout matches the metal plate shown in figure 3.
- Install the desired downlight (not supplied) ensuring the clips are resting on the metal plate and that the power supply module is resting on the top of the metal plate.
- Restore power to the light fixture.
WARRANTY
- 1 YEAR WARRANTY
Maxxima extends a 1 year limited warranty to the original purchaser that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
- info@maxximastyle.com
- 866-MAXXIMA (629-9462)
- www.maxximastyle.com
- 125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>