MINKA LAVERY 2679-695 Ricochet 8-Light Soft Brass Island Chandelier Instruction Manual
- June 12, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
For P5411-077-L / P5412-077-L / P5413-077-L / P5414-077-L
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
PREPARATION
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
- Secure mounting plate (B) to junction box (not included) using mounting screws (A) (Size: #8-32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2)
- Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided.
- Tuck wire connections neatly inside the junction box.
FINISHING THE INSTALLATION (Fig. 1)
- Place fixture body (F) over mounting plate (B) and secure with screws (E). Screw glass shade (G & G1) into fixture body (F).
Your installation is now complete. Return power to the junction box and test the fixture.
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to
the LEDs. Hold the fixture by the base or fixture body only.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switch.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>