MINKA LAVERY 2676-695 Ricochet 6-Light Soft Brass Contemporary Chandelier Instruction Manual
- June 12, 2024
- MINKA LAVERY
Table of Contents
2676-695 Ricochet 6-Light Soft Brass Contemporary Chandelier
Instruction Manual INSTALLATION INSTRUCTIONS
Item#2676-695 (New. 2022/04/18)
READ AND SAVE THESE INSTRUCTIONS
2676-695 Ricochet 6-Light Soft Brass Contemporary Chandelier
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION (Fig.1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1) -
Determine the desired hanging height and thread rods (F1, F2 and F3) to all thread (G) on the fixture body. Attach canopy (D) by screwing onto rod (F1). Carefully pass the wires through each rod during assembly.
-
Attach the mounting plate (A) to the junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate (A) with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
mounting plate (A) using the green screw provided. -
Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Place canopy (D) over mounting plate (A) and secure with screws (E).
-
Align metal panel (O) to metal frame (K) and secure with screws (P).
-
Install glass panels (J) into metal frame (K) and secure with the tabs and plastic sleeve provided.
-
Place metal frame (K) over socket (N) and secure with allen screw (L) using allen wrench (M).
-
Place candle covers (I) over sockets (N).
-
Install (6) six candelabra base bulbs (H) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>