MINKA LAVERY 2694-115 Yorkville 4-Light Aged Darkwood with Silver Patina Pendant Instruction Manual
- June 12, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 2694-115 Yorkville 4-Light Aged Darkwood with Silver Patina
Pendant
WARNING!
SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION (Fig.1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
-
Secure rod (J) onto all thread (K) on the fixture body.
-
Pass arm (H) through all thread (I) and insert both ends into location pins (L). Secure rod (G) onto all thread (I) on rod (J).
-
Determine the desired hanging height and thread rods (F1, F2 and F3) to the all thread on rod (G). Attach canopy (D) by screwing onto rod (F1). Carefully pass the wires through each rod during assembly. Note: Remove the all thread, if installing with one 6” rod only.
-
Attach mounting plate (A) to the junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5”).
The side of the mounting plate (A) with “GND” marked on it and two convex points must face out. -
The support cable is provided to support the weight of the fixture while wiring. Align the fixture to mounting plate (A) and attach hook (P) on the end of support cable (C) into a slot located on mounting plate (A). Carefully allow support cable (C) to support the weight of the fixture while wiring (Fig.1).
CONNECTING THE WIRES (Fig. 2)
- Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
- Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
- Place canopy (D) over mounting plate (A) and secure with screws (E).
- Place candle covers (N) over sockets (O).
- Install (4) four candelabra base bulbs (M) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification. —DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Documents / Resources
|
MINKA LAVERY 2694-115 Yorkville 4-Light Aged Darkwood with Silver Patina
Pendant
[pdf] Instruction Manual
2694-115, 2694-115 Yorkville 4-Light Aged Darkwood with Silver Patina Pendant,
Yorkville 4-Light Aged Darkwood with Silver Patina Pendant
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>