MINKA LAVERY 3363-416 Monico Vanity Bath Light Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
MINKA LAVERY 3363-416 Monico Vanity Bath Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
- Attach the mounting plate (A) to the junction box using the junction box screws (B) (SIZE: #8-32N, L0.5″). The side of the mounting plate marked “GND”must face out.
CONNECTING THE WIRES (Fig. 2)
- At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided. After the wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION (Fig.1)
- Place the fixture body (C) over the mounting plate (A), and secure with mounting screws (D).
- Align the glass shape (F) and screw shell (G) over the socket (E), and fasten with screw shell (G).
- Install (3) three medium base bulbs (H) up to 100 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Note : Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Your installation is now complete. Return power and test the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>