neno Kitty LED Light User Manual
- October 30, 2023
- neno
Table of Contents
neno Kitty LED Light
Dear Customer,
Thank you for purchasing the Neno Kitty LED light. The device is used to illuminate a room and is intended for domestic use. Please read the instruction manual before use.
PRECAUTIONS
- Read the instructions for use and keep them for later reference
- Follow the instructions carefully when using the device.
- Clean the appliance with dry material. Moisture can damage the inside of the unit.
- Ensure that the power cord is routed so that it does not pose a hazard to people passing by the unit.
- The device is for indoor use only.
- Do not place the unit near water, radiators, hot air vents, cookers or other sources of heat or moisture.
- Keep the power cord out of the reach of a child.
- The product is not a toy. Do not allow children to play with the device.
- If the product is damaged, do not dismantle it yourself. Contact an authorized service center.
KIT CONTENTS:
Kitty lamp, USB cable, remote control, instruction manual
USE OF THE DEVICE
I. Connect the light to the USB socket on your mains charger, power bank,
computer or laptop using the included USB cable. Make sure the cable is out of
the child’s reach. Make sure the power source meets the parameters of the
light (5V/0.5A). Using a power source that is too strong can lead to the unit
catching fire or other dangerous situations.
SEE FIG. A
- On/off
- Dimming
- Brightening
- Red
- Cold white
- Warm white
- Green
- Blue
- Orange
- Purple
- Gradual change of 7 colors
- Cyan
- Automatic switch-off mode after 60 min.
- Automatic switch-off mode after 15 min.
- Automatic switch-off mode after 30 min.
II. To the left of the charging socket is an LED that will indicate the
battery charge status. The red LED will be lit when charging and will go off
when the battery is fully charged.
III. You can control the light by touching the tail and trunk or via the
remote control
LIGHT CONTROL WITHOUT REMOTE CONTROL:
- To s witch on the light, press the cat’s tail.
- To change the brightness of the light or the color press and hold the tail.
- The light will start to change brightness and when it reaches its lowest intensity it will change color to cold or warm white.
- Another press of the tail will put the light into RGB mode. In this mode, the colors will automatically start to transition from one to another. You can also gently tap the kitty which will cause the RGB colors to change sequentially and the meowing sound.
- The next press of the tail will cause the light to switch off.
CONTROL OF THE LIGHT BY REMOTE CONTROL:
- Press the on/off button to turn the light on or off
- Press the „- „ button to dim the lamp
- Press the „+ „ button to brighten the lamp
- Press one of the 8 buttons to select the color of the light or the button with automatic RGB color-switching mode.
- Press one of the buttons „15min” „30min” or „60min” to have the lamp automatically switch off after the specified time. When one of the buttons is pressed, the lamp will dim and brighten to indicate that the time has been successfully set. To deactivate this mode, press the on/off button.
SPECIFICATION
- Material: silicone/ABS/PC
- Battery: 1200mAh allowing the light to be used for up to 100h at minimum light intensity and up to 8h at maximum light intensity.
- Input: DC5V 0.5A
- Power: 0.2-1.5W
- Light color temperature: warm light 3000K, white light 6500K + color RGB
- Dimensions: 155x102x81 mm
- Weight: 175g
- Charging time: approx. 4.5 h.
- Maximum radiated RF power in the frequency range: – 45 dBm
- Frequency range: 433 MHz
WARRANTY CARD
The product comes with a 24-month warranty. Warranty terms and conditions can
be found at: https://neno.pl/gwarancja
Details, contact and address of the service can be found at:
https://neno.pl/kontak
Specifications and kit contents are subject to change without notice. We
apologies for any inconvenience.
KGK Trend declares that this Neno Kitty device complies with the essential
requirements of Directive 2014/53/EU. The text of the declaration can be found
at:
https://xblitz.pl/download/DOC/deklaracja-CE-Neno-Kitty.pdf
The crossed out trash can symbol indicates that unusable electrical or
electronic devices, its accessories (such as power supplies, cords) or
components (for example batteries, if included) cannot be disposed of
alongside with household waste. In order to dispose of the devices or its
components (for example of batteries) deliver the device to the collection
point, where it wi I be accepted free of charge. Disposal is subject to the
recast version of the WEEE Directive (2012/19/ EU) and the Directive on
batteries and accumulators (2006/66 /
EC). Proper disposal of the device prevents degradation of the natural
environment. Information about the collection points of the facilities is
issued by the competent local authorities. Incorrect disposal of waste is
subject to penalties provided for by the law in force in the given area.
Customer Support
Producent:
KGK TREND Sp. z o.o.
ul. Ujastek 5b, 31-752 Kraków, Polska.
Wyprodukowano w PRC
Manufacturer:
KGK TREND Sp. z o. o.
st. Ujastek 5b, 31-752 Cracow, Poland.
**Made in PRC
**
Documents / Resources
| neno
Kitty LED
Light
[pdf] User Manual
Kitty LED Light, Kitty, LED Light, Light
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>