COOPER Lighting Solutions WaveLinx Wireless Area Controller User Manual
- June 10, 2024
- COOPER Lighting Solutions
Table of Contents
COOPER Lighting Solutions WaveLinx Wireless Area Controller
Product Information
The WaveLinx Wireless is a lighting control system offered by Cooper Lighting Solutions. The system consists of Wireless Area Controllers (WACs) that are installed at specific locations to manage the lighting in those areas. The system can be used in both networked and standalone configurations. The WACs are identified by their MAC IDs, which are required for programming the system.
Network Information
If the control system is to reside on a building network, the following information is required:
- Site Default IP Address
- Subnet Mask
- Default Gateway
- DNS IP
- Wireless Area Controller Name/ID
- Network Username
- Network Password
- MAC Address (complete)
- WAC Location (Floor and Location Installed)
- IP Address (for each WAC)
If there are additional network devices, a range of IP addresses should be provided.
For more information, please refer to the WaveLinx Installation Instructions available on the Cooper Lighting Solutions website.
Product Usage Instructions
To use the WaveLinx Wireless lighting control system, follow these steps:
- Install the Wireless Area Controllers (WACs) at the desired locations.
- Identify the last four digits of the MAC ID for each WAC. This information can be found on the WAC device.
- If the control system is to reside on a building network, provide the required network information as listed above.
- Program the system using the MAC IDs of the WACs.
- Manage the lighting in each area using the WACs and the programming software.
If you have any questions or require technical assistance, please contact Cooper Lighting Solutions at Controltechsupport@cooperlighting.com or call 1-800-553-3879.
WaveLinx Wireless – Network Information Cooper Lighting Solutions
Drawings
Please provide the site’s layout with documentation.
On the layout, indicate the following:
- Location of where the WAC(s) are installed.
- The last four digits of the WAC’s MAC ID for each location
Note: Last 4 digits can be found on the WAC device.
- This information is required to identify the WAC(s) and for programming.
- For complete information, please review the WaveLinx Installation Instructions on our website.
Network Information
(To be completed if Control System is to reside on Building Network)
Site Default IP Address (xxx.xxx.xxx.xxx)
| Subnet Mask|
---|---|---
Default Gateway|
DNS IP|
Networked or Stand-Alone System?
| Networked|
Stand-Alone System|
If on a Networked System, provide:
| Network Username|
Network Password|
Wireless Area Controller Name/ID
|
MAC
Address (complete)
| WAC Location (Floor and Location Installed)|
IP Address
|
WAC #1| | |
WAC #2| | |
WAC #3| | |
WAC #4| | |
If there are additional Network Devices, please provide a range of IP Addresses.
IP Address Range| | through|
---|---|---|---
- US: Please e-mail the completed form to LCServices@cooperlighting.com.
- Canada: Please e-mail the completed form to CanStartup@cooperlighting.com.
- For any questions on the material above please contact Cooper Lighting Solutions at Controltechsupport@cooperlighting.com.or call 1-800-553-3879 for additional information.
Cooper Lighting Solutions
- 1121 Highway 74 South
- Peachtree City, GA 30269
- P: 770-486-4800 www.cooperlighting.com.
- For service or technical assistance:
- 1-800-553-3879
Canada Sales
- 5925 McLaughlin Road
- Mississauga, Ontario L5R 1B8
- P: 905-501-3000
- F: 905-501-3172
© 2022 Cooper Lighting Solutions All Rights Reserved. Product availability, specifications, and compliances are subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>