IMI HEIMEIER 52720015 Tempset Thermostatic Balancing Valve Installation Guide
- June 4, 2024
- IMI HEIMEIER
Table of Contents
IMI HEIMEIER 52720015 Tempset Thermostatic Balancing Valve
Heimeier Tempset
Installation (Diagram B)
Fit Heimeier Tempset in each circulation riser, either at the top or bottom of the riser. Make sure that the valve is fitted the right way round (an arrow on the valve body indicates the direction of flow) and not closer than 0.5 m (1.65 ft) from the return pipe.
Temperature setting (Diagram A)
- Slacken the locking screw with the 2.5 mm Allen key, and unscrew it until it projects slightly above the handwheel.
- Turn the handwheel anticlockwise to stop.
- Set the required temperature against the casting line along the centre of the valve body (see the dotted line).
- Tighten the locking screw.
Shut‑off (Diagram A)
- Slacken the locking screw with the 2.5 mm Allen key, and unscrew it until it projects slightly above the handwheel.
- Turn the handwheel clockwise to stop. Resetting the temperature (Diagram A)
- Turn the handwheel anticlockwise to stop. Set the required temperature against the casting line along the centre of the valve body (see the dotted line).
- Tighten the locking screw.
Diagram A
- Temperature gauge
- Lug for identification tab
- Temperature scale
- Locking screw
- Allen key for locking screw (2.5 mm) 6 Casting line
Diagram B
- Heimeier Tempset
- Shut-off valve
- Domestic hot water circulation pump
- Non-return valve
- Heat exchanger
We reserve the right to introduce technical alterations without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>