LeoVince LV-10 Slip On Exhaust Instruction Manual
- June 10, 2024
- LeoVince
Table of Contents
LeoVince LV-10 Slip On Exhaust
LIST OF COMPONENTS
- Muffler
- Muffler
- Fitting kit
- Bracket
STAINLESS S.
cod. 3015247481
cod. 3015247483
cod. 3015247601
cod. 3015247501
BLACK
cod. 3015247485
cod. 301524748
cod. 3015247601
cod. 3015247501
SPARE PARTS
TRIUMPH SPEED TRIPLE 1200 RR/RS
A FITTING KIT cod.3015247601R
FITTING INSTRUCTION
LIST OF SUPPLIED PARTS:
Refer to the list of components and the product drawing included in this
booklet.
WARNING:
Before carrying out any work on the exhaust, check that its surface has cooled
so that it will not damage components, which are not heat-resistant (such as
fairing, hoses, rubber sleeves, etc.), or the operator.
INSTALLATION:
- Remove the OE silencer.(Photo N°1).
- Slide the Leovince silencers (Photo N°2) onto the link pipes, check the alignment of the mounting eyes for the springs and the alignment of the exhaust outlet to the rear of the silencer, and then link the parts together with the springs provided
- Mount spacers, washers and brackets (if any) as shown on the drawing and then secure by tightening nuts and bolts. (Photo N°3-4).
- Tighten the various clamps which join the Leovince link pipe to the OE exhaust headers.
- Start the engine, wait a few minutes until it reaches operating temperature, and check that there are no gas leaks.
WEIGHT- (Kg)
STOCK – 3,75 (Kg)
| Stainless steel| S.s black| Titanium
LeoVince| 2,28| 2,28| /
IMPORTANT:
During the first km of running, the exhaust system needs breaking-in;
therefore, slight gas leakage might occur. After approximately 100 Km, check
all the fasteners.
ADJUSTEMENT:
This silencer has been developed by Leovince on an electronic dynamometer
using a vehicle in perfect condition, and in standard trim
MAINTENANCE:
From time to time, check all the brackets and fasteners, which could be
affected by use (sound-deadening material, seals and other rubber parts) and
replace them periodically. The silencer may be cleaned using gasoline, diesel
oil or alcohol. Absolutely avoid the use of any kind of solvent. It is normal
for there to be some discoloration of the silencer, which is the result of
heat and the nature of the materials used.
IT IS FORBIDDEN to modify silencers. Whatever form this may take, Belgrove Sp. z o.o. declines any responsibility for defects, problems, or malfunction, arising from the use of any product which has been modified or tampered with.
We suggest the fitting to be made by professionals
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>