AFX MOTORSPORTS TEC051 Aluminum Roof Installation Guide
- June 11, 2024
- AFX MOTORSPORTS
Table of Contents
**AFX MOTORSPORTS TEC051 Aluminum Roof Installation Guide
**
THANK YOU FOR PURCHASING AT AFX MOTORSPORTS
HOW TO INSTALL
Tools Needed (Not Included)
- 5/32” Allen Key
- 7/16” or 14 mm Combination Wrench
Liability Statement
AFX Motorsports products are designed to best fit user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts
will void any warranty provided by AFX Motorsports and is not recommended. AFX
Motorsports products could interfere with other aftermarket accessories. If
user has aftermarket products on machine, contact AFX Motorsports to verify
that they will work together. Although AFX Motorsports has thousands of
satisfied customers, user should be aware that installing bumpers, rock
sliders, spare tire carriers, etc. will change the ride of machine and may
increase maintenance and part wear. Operating any off-road machine while, or
after, consuming alcohol and/or drugs increases risk of bodily harm or death.
No warranty or representation is made as to this product’s ability to protect
user from severe injury or death. AFX Motorsports urges operators and
occupants to wear a helmet and appropriate riding gear at all times. By
purchasing and installing AFX Motorsports products, user agrees that should
damages occur, AFX Motorsports will not be held responsible for loss of time,
use, labor fees, replacement parts, or freight charges. AFX
Motorsports, nor any 3rd party, will not be held responsible for any direct,
indirect, incidental, special, or consequential damages that result from any
product purchased from AFX Motorsports. The total liability of seller to user
for all damages, losses, and causes of action, if any, shall not exceed the
total purchase price paid for the product that gave rise to the claim. AFX
Motorsports will warranty only parts provided by AFX Motorsports. Any damage
or problems with OEM housings, bearings, seals, or other manufacturers’
products will not be covered by AFX Motorsports. AFX Motorsports parts and
products are not warrantied if item was not installed properly, misused, or
modified.
- In case of having the OEM Plastic Roof: Uninstall the original plastic roof of the vehicle, removing the screws
- Install the anti-rattling strip provided in the middle of the vehicle’s rollcage tubes, where the roof will be placed
- Position the roof, and align the holes in the aluminum roof with the original holes in the roll cage
- Attach the rear with two 1/4″ x 1 1/2″ screws, four washers and two nuts, also use the Special washers and Spacers. Attach the front of the roof with two 1/4″ x 1″ screws, four washers and two nuts (Do not tighten yet)
Then use the four Side Supports to fasten the roof on the roll cage, use four 1/4″ x 1″ screws, four nuts and eight washers and finally tighten all the screws and nuts
For technical support , please write us to: support@afxmotorsports.com or call us at: Ph. 956-242-6521
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>