AFX MOTORSPORTS TEC050 Aluminum Roof Polaris Ranger XP Installation Guide
- June 11, 2024
- AFX MOTORSPORTS
Table of Contents
AFX MOTORSPORTS TEC050 Aluminum Roof Polaris Ranger XP
THANK YOU!
FOR PURCHASING AT AFX MOTORSPORTS
HOW TO INSTALL
Pieces included:
Hardware:
- (16x) 1 /4″ x 1″ Button Screw
- (x l 6) 1 /4″ Nuts
- (x16) 1 /4″ washers
Tools Needed {Not Included)
- 5/ 32″ Allen Key.
- 7 / 16″ or 14 mm Combination Wrench.
Liability Statement
AFX Motorsports products are designed to best fit user’s ATV/UTV under stock conditions. Adding, modifying, or fabricating any factory or aftermarket parts will void any warranty provided by AFX Motorsports and is not recommended. AFX Motorsports products could interfere with other aftermarket accessories. If user has aftermarket products on machine, contact AFX Motorsports to verify that they will work together. Although AFX Motorsports has thousands of satisfied customers, user should be aware that installing bumpers, rock sliders, spare tire carriers, etc. will change the ride of machine and may increase maintenance and part wear. Operating any off-road machine while, or after, consuming alcohol and/or drugs increases risk of bodily harm or death. No warranty or representation is made as to this product’s ability to protect user from severe injury or dea1h. AFX Motorsports urges operators and occupants to wear a helmet and appropriate riding gear at all times. By purchasing and installing AFX Motorsports products, user agrees that should damages occur, AFX Motorsports will not be held responsible for loss of time, use, labor fees. replacement parts, or freight charges. AFX Motorsports, nor any 3rd party, will not be held responsible for any direct, indirect, incidental, special, or consequential damages that result from any product purchased from AFX Motorsports. The total liability of seller to user for all damages, losses, and causes of action, ff any, shall not exceed the total purchase price paid for the product that gave rise to the claim. AFX Motorsports will warranty only parts provided by AFX Motorsports. Any damage or problems with OEM housings. bearings, seals, or other manufacturers’ products will not be covered by AFX Motorsports. AFX Motorsports parts and products are not warrantied if item was not installed property, misused, or modified.
➊ In case of having the OEM Plastic Roof: Uninstall the original plastic roof
of the vehicle, removing the screws located on the rear and front part.
➋ Install the anti-ratting strip provided in the middle of the rollcage tubes,
where the roof will be placed.
➌ Place the rear roof in position, installing the bolts with the washers and
nuts, as it shown in the image. (do not thighten yet)
➍ Place the second part of the roof, aligning the holes with the bolts
supplied. As it is shown in the image.
➎ Use the 4 brackets in order to tight both parts of the roof on the middle
bar of the roll cage.
Use bolts washer and nuts as well, as it is shown in the image.
➏ Use the 4 tube clamps in order to tight both parts of the roof on the middle
bar of the roll cage. Use bolts washer and nuts as well, as it is shown in the
image.
➐ Make sure step 1 through 6 are completed and proceed to tighten the full
assembly of the aluminum root.
Customer Service
For technical support , please write us to:
support@afxmotorsports.com or call us at:
Ph. 956-242-6521
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>