Maxxima MRL-S41523 4 in. Low Kelvin Round Canless Recessed LED Downlight Installation Guide
- June 9, 2024
- Maxxima
Table of Contents
MRL-S41523 4 in. Low Kelvin Round Canless Recessed LED Downlight
Installation Guide
MRL-S41523 4 in. Low Kelvin Round Canless Recessed LED Downlight
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- Supply conductors must at least be rated for 90°C/194°F.
- This fixture is designed for use with 120Vac, 50/60Hz only.
INSTALLATION INSTRUCTIONS
-
Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
-
After marking the center point of where the fixture will be located, using the provided template cut the required hole shown in figure 1 which has a diameter of 4inches or 108mm.
-
Open the junction box, remove the desired knockout and attach a twin screw clamp connector (or similar).
-
Insert the supply wire through the twin screw clamp connector (or similar) shown in figure 2a.
-
Connect the hot (black) wire to the black wire, the neutral (white) wire to the white wire and the ground (green/bare copper) wire to the green wire using the provided wire nuts shown in figure 2.
5a. Optional – Using the selector switch inside the metal junction box the CCT can be changed to any of the three settings (CCT settings are 2200K/2400K/2700K). -
Put all of the wires into the metal junction box and close the junction box.
6a. Optional – using a screw (not provided), the junction box can be mounted using the holes in the back of the junction box. -
Connect the male output connector from the junction box with the female connector from the fixture and tighten the locking nut.
-
To insert the fixture into the hole, hold the two spring clips in the vertical position until the springs are past the top of the ceiling material shown in figure 4.
-
Push the fixture up until flush with the ceiling shown in figure 5.
-
Installation is now complete, restore power and the fixture is now operational.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com
866-MAXXIMA (629-9462)
MRL-S41523
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>