Chargers Chair Style Stand Wireless Charger User Manual
- June 10, 2024
- Chargers
Table of Contents
Chargers Chair Style Stand Wireless Charger
Instructions for use
-
Connect USB cable into the power input jack.
Another side of USB can insert to any USB power source, can be Power bank, Adapter etc. -
Note: Only when the power source marked with QC3.0{Or may QC2.0/4.0), the wireless charger Can work on a power output> 5Watt.
If you don’ t have a QC marked USB power, at least should use a power source> 5V2A. -
After powered up, you can wireless charging at 1 of 3 below style.
FAQs
-
Can’t wireless charging:
Please confirm: Whether the phone support wireless charge function?
If yes, make sure there are no any metal, or any kind of conductor material beween the phone and wireless charger. -
Charging slow, or intermittent:
Check whether the phone’ s wireless receive position 100% allign with the induction area.
Check the USB power source>SV2A(Don’ t use the USB of computer etc, these USB power lower than SVlA} Suggest use QC3.0 marked USB power.
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or tv interference caused by
unauthorized modifications or change to this equipment.
Such modifications or change could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCc’ s RF exposure guidelines, this equipment should be installed and operated with a minimum distance of20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>