XTOOL D1 Laser Engravers User Guide
- June 3, 2024
- XTOOL
Table of Contents
XTOOL D1 Laser Engravers
Dear XTooler:
Thank you for purchasing xTool DI. We are so grateful for your recognition,and
sincerely hope you will enjoy this product!
XTool DI is a high-accCuracy and high-power laser engraver and laser cutter.
From novice to expert, from home use to business, xTool Dl is ready to give
you the best laser engraving & cutting experience.
Our mission is to make it easier for everyone to create with our machine.
We attach great importance to product experience and user suggestions.
Please let us know if you have any questions at anytime, we are always here to
help. You can join our facebook group which gathers 25000+ innovators like
you, to share creative ideas and get inspired by others.
By visiting our online store, you can also find our latest accessories and
various materials to maximize the magic of xTool D1.
Thanks again for your support, and we will consistently provide quality
products and services in the future.
Sincerely,CEO
Official Website: www.xtool.com
Facebook Group: XTool DI Official Group / Makeblock xTool Official Group
Support Center: support.xtool.com
Technical Support: support@xtool.com
Unbox and check
The secret to getting ahead is getting started.
Are you ready to embark on a creative journey?
Let’s go!
Assemble XTool DI
The screws are used to set the tension of the timing belts. Do not fully tighten them. Otherwise, the timing belts may be damaged.
lf you can’t put the optical shaft through the timing belt, the possible cause is that the timing belt is set too tight. You can adjust its tension by turning the screw.
slide the two sliders down against the front plate.
Fully tighten the two screws.
Pay attention to the front and back sides of the connector. Insert it properly.
No scissors are included in the pack.
Pay attention to the front and back sides of the connectors.
Insert them properly.
The screw is used to set the tension of the timing belt. Do not fully tighten it. Otherwise, the timing belt may be damaged.
80% done!
Excited to see your laser cutter begins to take shape!
Success Is Just around the corner!
Ensure that the cable sleeve is placed in the slot.
Reserve a sufficient length of the cable to allow the laser module to slide between the left and right plates.
Congratulations!
You have completed the installation!
Meet your xTool DI
Set up xTool D1
Adjust the tension of the timing belts
Try to set the timing belts on the right and left plates to the same tension, so that xTool DI can cut and engrave materials properly.
Set the position of the laser module
- Put the focal length setting bar down
- Loosen the thumb screw on the other side and slide the laser module upward or downward
- After determining the position,tighten the thumb screw and put the focal length setting bar back
Download and install software
You can operate xTool D1 by using our official software or the third-party software LightBurn.
Note: You need to purchase LightBurn before using it.
Connect Rotary Attachment
You can connect XTool DI to Rotary Attachment to engrave cylindrical object.
Rotary Attach ment needs to work witha device and software.
For details about how to use it, visit support.xtool.com.
Place Rotary Attachment parallel to the working area of XTool Di.
Before you connect it to xTool D1, you may need to set its level based on the
diameter of the material to be processed.
Level reference
Set the level
Use the changing of the level from 3 to 2 as an example.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>