YECAYE CMC-03 125 Inch Cord Hider – One-Cord Channel Cable Concealer Installation Guide
- June 6, 2024
- YECAYE
Table of Contents
YECAYE CMC-03 125 Inch Cord Hider – One-Cord Channel Cable Concealer
Installation
Plan the Route
Plan the route of channels on your wall and which connectors you will need to use. Refer to the diagram below to determine the purpose of each unique connector.
Measure Location(s)
Measure the distance and mark the points on the wall. Tip: BEFORE adhering
to the wall, verify the spacing needed between Channel connector(s) for proper
fit.
Cut to Length(s)
Mark the exact cut spot on the channel with a pencil, and cut it.
Apply the tape
Stick the adhesive tape onto the back of the channel. Peel off the adhesive
backing.
Press Firmly in Place
Press firmly against the wall to ensure the channel sticks properly.
Put in cables
place the cables inside the channel.
Put on Connectors and Covers
Put the connector(s) in place, and slide or snap on the channel cover.
Optional Installation with Screws
For models equipped with screw hardware.
- Place the channel base against the wall and mark the holes for installation, using a level as a guide. If the channel is not pre-drilled, you’ll need to drill a few holes first.
- Drill holes where you marked on wall and tap the wall anchors into place.
- Move the channel base back into position and secure it with screws.
- Place inside the cables, snap or slide on the cover.
Frequent Customer Questions &Answers
You may notice some PVC shavings Do not worry, our product is brand new. Our channels are cut relatively short to facilitate easier handling. Also, it is quite normal to have some shavings, just wipe them away with a damp cloth.
Difficulty in removing the white backing from the mounting tape?
Lift the backing from the corner by using your fingernail, a needle, or a
blade. You can also pinch and stretch the corner of the mounting tape until
the backing lifts from the tape.
How to remove the channel?
Our mounting tape is strong, after installation, it will stay well in one
place, so please mount it(stick-on) carefully! When removing, warm it up with
a blow dryer(better a heat gun if you have one) to soften the adhesive, then
peel it off slowly without damaging the surface.
Missing pieces or broken pieces?
Our product is well packed as a complete set in the Amazon warehouse.
However, Amazon workers may send out returned items from previous buyers to
new customers by mistake. If this happens to you, please contact us
immediately. We’ll offer a refund or replacement as soon as possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>