HYPERKIN PS2 HDTV Cable User Guide
- June 14, 2024
- HYPERKIN
Table of Contents
HDTLUD CABLE ForPs2: Ps1°
Quick Start Guide
PS2 HDTV Cable
Setting up the HDTV Cable for PS2°
- You need to make sure your PS2° is set to “RGB”. Start by using your PS2®’s AV cables to access the System Configuration menu. Under Component Video Out, select “RGB”. After choosing this setting, turn off your PS2°.
- Insert the HDTV Cable into your PS2°’s AV Multi Out port. Insert the other end into your HDTV (or any HD display).
- Connect the included Micro cable to the Micro port and the other end to a 5V 1A USB power source (not included).
Setting up the HDTV Cable for PS1®
- Insert the HDTV Cable into your PS1*’s AV Multi Out port. Insert the other end into your HDTV (or any HD display).
- Connect the included Micro cable to the Micro port and the other end to a 5V 1A USB power source (not included).
Aspect Ratio Switch
BEFORE powering on your cable, make sure your aspect is configured. Moving the switch to the LEFT position indicates a 4:3 ratio. Moving the switch to the RIGHT position indicates a 16:9 ratio.
Cable Status Guide
The colored LED INDICATOR LIGHTS on your cable tells you your cable’s status. The BLUE light indicates that the cable is transmitting signal. The RED light indicates the cable is powered ON.
Both Blue and Red Light On = Cable is working
Red Light Only = Sleep Mode
If your cable has no signal for 10 minutes, it will switch to Sleep Mode.
Note: If your cable is not functioning correctly, an additional power source
might be required. Connect the included Micro cable into the Micro port on the
HD Cable and the other end into a 5V 1A USB power source. Power source is not
included.
Statement of Compliance with EU Directive
Hyperkin Inc., located at 1939 West Mission Blvd, Pomona, CA 91766,
declares under our sole responsibility that the product, HDTV Cable for
PS2®/PS1®, is in compliance with the essential requirements and other relevant
provisions of Low Voltage Directive (LVD) 2014/35/EU, RoHS Directive
2011/65/EU, and carries the CE marking.
The full Declaration of Conformity can be requested by emailing:
Email: Compliance@Hyperkin.com
Company Name: Hyperkin Inc.
Address: 1939 West Mission Blvd, Pomona, CA 91766
© 2020 Hyperkin Inc. Hyperkin® is a registered trademark of Hyperkin Inc.
PS2®, PS1®, and PlayStation® are registered trademarks of Sony Interactive
Entertainment Inc. This product is not designed, manufactured, sponsored,
endorsed or authorized by Sony Interactive Entertainment Inc. in the United
States and/or other countries. All rights reserved. Made in China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>