intempo 5 METRE LED LIGHT STRAIP Instruction Manual
- June 7, 2024
- intempo
Table of Contents
intempo 5 METRE LED LIGHT STRAIP Instruction Manual
Description of Parts
Light Strip
- 5 M LED Light Strip
- LED Port
- LED Wheel
- Back Paper
- Remote Control
- Cutting Indicator Circles
- Mains Power Adaptor
Remote Control
- On Button
- Off Button
- Color Button
- Brightness Button
- Dimmer Button
- Flash Button
- Strobe Button
- Fade Button
- Smooth Button
Please read all of the instructions carefully and retain for future reference.
Safety Instructions
When using electrical appliances, basic safety precautions should always be
followed. Children aged from 8 years and people with reduced physical, sensory
or mental capabilities
or lack of experience and knowledge can use this appliance, only if they have
been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Unless they are older than 8 and
supervised, children should not use, perform cleaning or user maintenance.
This appliance is not a toy.
This appliance contains no user serviceable parts. If any part of the
appliance is malfunctioning, or if the appliance has been dropped or damaged,
only a qualified electrician should carry out repairs. Improper repairs may
place the user at risk of harm.
Keep the appliance out of the reach of children. Keep the appliance away from
heat or sharp edges that could cause damage.
Do not immerse the electrical components of this appliance in water or any
other liquid.
Do not leave the appliance unattended whilst it is switched on.
Do not use the appliance if it has been dropped, if there are visible signs of
damage.
Do not use the appliance for anything other than its intended use.
Do not use any accessories other than those supplied.
Do not store the appliance in direct sunlight or in high humidity conditions.
Do not remove the adaptor from the mains power supply by pulling the cord;
switch off and remove the plug by hand.
Do not use the adaptor to recharge non-rechargeable batteries or any other
appliance.
Do not use the appliance for anything other than its intended use.
Use of an extension cord with the appliance is not recommended.
Only use the appliance with the power supply unit provided.
This appliance should not be operated by means of an external timer or
separate remote control system. Switch off the appliance before changing or
fitting accessories. Always switch off the appliance after use and before any
cleaning or user maintenance. This appliance is intended for domestic use
only.
It should not be used for commercial purposes.
Care and Maintenance
Before attempting any cleaning or maintenance, make sure that the LED strip is turned off. Wipe down the LED strip with a soft, damp cloth and dry thoroughly.
Do not:
Do not use abrasive cleaning solvents to clean the LED strip.
Do not immerse the LED strip in water or any other liquid.
Do not expose the remote control to extremely high or low temperatures, as
this may destroy the battery.
Instruction for Use
Using the 5 M LED Light Strip
STEP 1: Clean the area where the LED strip will be placed. Connect the
mains power adaptor to the LED port on the LED Light Strip.
STEP 2: Unravel the LED strip from the LED wheel and lay on a flat,
stable surface. Measure out the desired length for the LED Strip
STEP 3: Cut the LED strip at the closest cutting indicator circle to the
desired length.
STEP 4: Carefully remove the paper from the back of the LED strip to
reveal the adhesive side of the strip.
STEP 5: Stick the strip to the desired area. Plug the mains power adaptor
into the mains power supply and switch on. The LED strip will flash to signal
that it has been plugged in.
STEP 6: Use the remote control to switch the LED strip on. The remote
control can also be used to cycle through the light modes on the LED strip and
to turn it off.
Note: Make sure that any cuts made to the LED strip are made at the end
of the LED strip that is furthest from the power supply. If the LED strip is
disconnected from the mains
power supply whilst switched on, when it is reconnected the lights will turn
on automatically
Specifications
Product Code: EE5847STKUK
Adaptor Input: 220-240 V ~ 50-60 Hz 0.5 A
Adaptor Output: 24 W 2 A
Working Voltage: 220-240 V =
LED Strip Length: 5 M
Manufactured by
UP Global Sourcing UK ltd.,
Victoria Street, Manches1er Ol9 ODD. UK.
Made in China.
www.intempo.co.uk
CD140720MDOOOOOON1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>