beper P302VIS050 LED Light Mirror User Manual

beper P302VIS050 LED Light Mirror

Precautions

Read the following instructions carefully, since they give you useful safety information about installation, use and maintenan-ce and help you avoid mishaps and possible accidents. Remove the packing and make sure that the appliance is intact, with special attention to the supply cable.

The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing ma-terial in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually infor-mation to the manager of the Sanitation Department of your own mu-nicipality.

If the supply cord is damaged, it must be replaced by the manufac-turer, its service agent or similarly qualified persons in order to avoid a hazard.
Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label.
The appliance can be damaged if the voltage is not correct.

If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption.

Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded.

Do not use the appliance if the cable or the plug shows any damages. Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance.

This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manu-facturer cannot be responsible for any damages deriving from impro-per, wrong or incautious use.

This appliance is for household use only. To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids. Do not use the appliance near explosives, highly flammable mate-rials, gases or burning flames. Do not allow children, disabled people or every pe- ople without experience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children.

**Product description

**

1. Main unit
2. Organizer base
3. Main switch
4. Battery case
5. USB cable inlet
6. LED lights ON/OFF key
7. LED lights
8. USB cable

Warnings for use

• Keep this manual for any future reference.
• Remove all packaging materials before using the item, and make sure to keep these materials out of the reach of children and pets.
• Do not use the item in case of malfunctioning, or in case of accidental drops/damages, or if it has been immersed in water or other liquids.
• Do not attempt to repair/modify the item in any way.
• Do not use this item where aerosol (spray) products are used or where oxygen is administered.
• Do not use this appliance outdoors and do not expose it to atmospheric agents.

Important: the side mirrors with magnifying effect may show a slight curvature, due to the specific processing carried out on the glass; this curvature is normal, and it is not to be considered a defect of the product.

Assembling and operation

• After removing all packaging materials, insert the main unit inside the dedicated hole found on the organizer base, applying a light pressure.
• Place the assembled mirror on a flat and stable surface. The tilt of the mirror can be adjusted up to 180°, while its rotation can be adjusted by 90° towards left or right.
• This mirror can be operated with 4 type AAA batteries (not included), or connected to the mains source via the USB cable provided. In case of battery operation, open the battery case at the back and insert the batteries, fol-lowing the polarity indicated. In case of USB operation, insert the cable inside the inlet at the back, and connect USB plug to a USB port.

Warning: remove batteries when the mirror is connected to a USB port, or in case it is not used for long periods of time.

To activate LED lights, first of all place the main switch on I (ON), then press the ON/OFF key found at the center of the mirror. To switch the lights off, press the ON/OFF key again.
Once done using, place the main switch on O (OFF), and, if applicable, unplug the USB cable.

Cleaning and maintenance

• Make sure that the main switch is placed on O, and the USB cable is disconnected and/or the batteries have been removed.
• Remove dirt and/or prints from the mirror using detergents purposely designed for glass surfaces and a soft cloth.
• Clean the back of the main unit and the organizer base with a soft cloth, slightly dampened if needed.

Warning: do not immerse the item in water or other liquids; make sure no liquid penetrates inside the battery case, USB cable inlet and, in general, the main unit.

Store this item in a dry and clean place, away from dust and humidity. Remove batteries when not used for long periods of time.

Technical data

Power source: 4xAAA (not included) / 5V DC USB
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.

GUARANTEE CERTIFICATE

This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee ap-plies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.

The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance For any technical assistance, please contact directly the seller or our head office in order to preserve the applian-ce’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee.

GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:

• The appliance has been used properly and for the purpose for which it has been intended.
• The appliance has not been tampered with, otherwise it is not maintainable.
• The purchase receipt shall be presented.
• The appliance showing a fair wear and tear shall not be covered by this guarantee.

Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.

For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product

Contact your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward your enquiries to your distributor.

BEPER SRL

• ADDRESS: Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
• Tel:  045/7134674
• Fax: 045/6984019
• beper.com

References

• Home - Beper

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>