beper 50.451 Cyclonic Vacuum Cleaner Instruction Manual
- June 9, 2024
- beper
Table of Contents
CYCLONIC VACUUM CLEANER
50.451 Cyclonic Vacuum Cleaner
For further information and/or for instructions for use in other languages , please visit: beper.com
Precautions
Read the following instructions carefully, since they give you useful safety
information about installation, use and maintenance and help you avoid mishaps
and possible accidents.
Remove the packing and make sure that the appliance is intact, with special
attention to the supply cable.
The elements of the packing (plastic bags, polystyrene, etc) do not have to be
accessible to the children, in order to preserve them from danger sources. It
is recommended not to throw these packing material in the domestic waste, but
to deliver them to the appropriate station of collection or destruction
refusals, asking eventually information to the manager of the Sanitation
Department of your own municipality.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Before connecting the appliance make sure that the mains voltage corresponds
to the data specified on the label.
The appliance can be damaged if the voltage is not correct. If the plug does
not suit the socket, let it be replaced with another suitable plug by
qualified personnel only, which shall also ensure that the section of the
socket cables is suitable for your appliance power absorption. Generally, the
use adaptors multiple plugs and/or extensions is not recommended; should they
be necessary, please use only simple or multiple adaptors and extensions in
compliance with the safety rules in force, making sure that the capacity
absorption limit marked on the simple adaptors and the extensions and the
maximum power limit marked on the multiple adaptor are not exceeded.
Do not use the appliance if the cable or the plug shows any damages.
Do not use the appliance after a possible irregular working. In this case,
switch it off and do not break it open. Refer to an authorized Beper after-
sale service for repair and require original spare parts only. Failing to
follow these instructions may impair the safety of your appliance.
This appliance is to be destined to its special purpose only. Any other use is
to be considered as improper and thus dangerous. The manufacturer cannot be
responsible for any damages deriving from improper, wrong or incautious use.
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any parts of
the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable materials, gases or
burning flames.
Do not allow children, disabled people or every people without experience or
technical ability to use the appliance if they are not properly watched over.
Close supervision is necessary when any appliance used by or near children.
Description Fig. A
- Handle
- Upper cable hook
- Bottom cable hook
- On/Off switch
- Dust container release button
- Dust container
- Hepa filter
- Floor brush
Operation
Warning: this vacuum cleaner sucks only dust: solid objects of size bigger
than 2-3 cm can clog the vacuum cleaner!
Before turning on the appliance, make sure that the Hepa filter and the dust
container are correctely assembled.
Turn the upper cable hook to allow the power cord to release, extend the power
cord completely and check that it is free of tangles.
Insert the plug into an electrical outlet.
Press the power switch on I.
At the end of the suction, switch off the appliance by pressing the switch and
positioning it on 0.
Remove the plug of the power cord from the electrical socket. Rewind the power
cord on the appropriate hooks. When the powder container fills at
approximately 50-60%,
it is advisable to empty it and clean the filter.
Cleaning
The filters are subject to a natural deposit of dirt, which decreases the
suction considerably. It is important to keep them clean in order to improve
the efficiency and the life of the vacuum cleaner.
Before doing the following operations, be sure that the vacuum cleaner is
turned off (the switch is pushed into the “0” position) and that the power
cord is unplug from the outlet. When the dust container is full, please empty
it.
Note: Use compressed air (compressor or specific air cylinder) in order to
clean the Hepa filter. It is advisable to substitute the old filter for a new
one at least once a year.
Hold the open button of the dust container in order to open and close it. Wash
the dust container with warm water and then dry it completely, before
replacing it inside the device.
Warning: Do not put the dust container inside the device if it is still
wet.
Technical specifications
Power consumption: 600W
Power supply: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the
product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the
materials they contain, and reduce the impact on human health and the
environment.
The crossed out “wheeled bin” symbol on the product reminds you of your
obligation, that when you dispose of the appliance, it must be separately
collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original
purchase a 24 month guarantee applies to material and production defects. The
purchase receipt
and the guarantee certificate must be submitted together in case of claim to
guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase
(fiscal receipt) indicating the date of purchase and the model of the
appliance
For any technical assistance, please contact directly the seller or our head
office in order to preserve the appliance’s efficiency and NOT TO void the
guarantee. Any intervention on his appliance by non-authorized persons will
automatically void the guarantee.
GUARANTEE CERTIFICATE
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is
an accessory and/or a detachable part of the product, Beper reserves the right
to replace only the very part in question and not the entire product Contact
your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward
your enquiries to your distributor.
BEPER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com
CUSTOMER CARE
BEPER
http://customercare.beper.com/support/home
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>