Kimberly-Clark Professional ICON Automatic Soap and Sanitiser Dispenser Installation Guide
- June 9, 2024
- Kimberly-Clark
Table of Contents
Kimberly-Clark Professional ICON Automatic Soap and Sanitiser Dispenser
Installation Instructions
Lock & Key Removal
-
Open the dispenser cover. Make sure to return the key to the horizontal locked position before removing the lock assembly.
-
If present, remove lock cover piece.
-
Support lock assembly from underneath with hand. Use a flathead screwdriver to remove retaining clip. Lock may fall into hand.
Install Push Button
-
Insert push button until lowest 2 side tabs fully engage. You should hear a click to signify correct action.
Important! 2 tabs should be underneath the leaf spring and 2 tabs should be above for button to function properly.
-
Slide lock cover back into place if removed.
-
Close dispenser cover and make sure it securely closes.
-
Ensure push button is flush with the top of the dispenser. Test the button a few times to ensure proper function.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>