OPT7 Quantum Rock Lights Bluetooth Installation Guide
- June 9, 2024
- OPT7
Table of Contents
OPT7 Quantum Rock Lights Bluetooth
COMPONENTS
WHERE TO INSTALL
RECOMMENDED LOCATIONS FOR ROCK LIGHT PODS
INSTALLATION STEPS
TOOLS REQUIRED
- 5/32-inch Drill Bit
- 7/64-inch Drill Bit Phillips
- Head Screwdriver
-
Designate your mounting locations for each Rock Light Pod and the control box. (Refer to page 4 for recommended mounting locations) Avoid hot surfaces and/or moving parts.
-
Use a pen to mark the holes where you want to mount the Rock Light Pods. Then, drill a 5/32” hole(s) for the wire connector to pass through.
-
Drill a 7/64” hole for each marked hole.
-
Secure the Rock Light Pods using the included screws. (If mounting on a rounded or uneven surface, utilize the optional rubber mounting pads.)
Caution: Rock Light Pods become extremely hot during use – keep away from any vehicle parts that may be damaged by exposure to high temperatures. -
Connect all Rock Light Pod wires to the control box connectors. Secure by twisting.
-
Connect the Red line(+) of power hareness to the vehicle battery’s positive terminal .
-
Connect the Black line (-) of power hareness to the vehicle battery’s negative terminal or an unpainted area on your vehicle’s frame.
-
Open the OPT7 CONNECT App, pair your smart device to the control box, and pick your desired color!
Optional: If you would like for the door assist function to be used, it is recom-mended to connect the door assist wire from the control box to a positive (+) light source that is turned on when the door is open or to the dome light. This will activate the Rock Lights to be ON when the door is turned on.
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
OPT7 CONNECT APP
- Colors
- Modes
- Door Assist
- Support
- Ability to control up to 4 devices at once
Download the free “OPT7 CONNECT” App
- App iOS (12+) available on App Store
- Android (6 +) available on Google Play
SPECIFICATIONS
- Wattage 8W Per Pod
- Amp Draw Quad-Core CREE
- 8 LEDs 8A
- Brightness 1,600 Lumens Per Pod
- Voltage 12 V
- Resistance IP68 Water-Resistant (Pod Only)
- Operating Temperature -20°-150°F
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
WARRANTY
2 YEAR
- Follow us on Instagram @opt7lighting
- Subscribe to our YouTube channel. Opt7Lighting