ITC 69810 Beam Courtesy Light Instruction Manual
- June 3, 2024
- ITC
Table of Contents
ITC 69810 Beam Courtesy Light
PARTS NEEDED
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
- It is recommended that fuse protection be added to the positive (+) input.
- Determine the installation location and drill a hole using the provided hole saw bit. Remove the set screw and nut from the back of the light.
- Pull the units wire through the hole making sure to put the nut on the inside before completing the wiring. Using the wiring diagram below, wire the light to the units power and test the light.
- Feed the wires back through the hole1 and tighten the nut2 on the back of the light. If possible tighten the set screw3. The set screw is not required for installation but provides added support.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC# 710-00023 • Rev B • 12/21/17
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>