GE Lighting 90986LO StayBright 300 6-ft x 8-ft Constant Multicolor Christmas Net Lights Instruction Manual
- June 9, 2024
- GE Lighting
Table of Contents
GE Lighting 90986LO StayBright 300 6-ft x 8-ft Constant Multicolor Christmas Net Lights
IMPORTANT SAFETY INSTRUCTIONS
When using electric products, basic precautions should always be followed including the following:
a) READ AND FOLLOW ALL SAFETY INSTRUCTIONS
b) Do not use seasonal products outdoors unless marked suitable for
indoor and outdoor use.
When products are used in outdoor applications, connect the product to a
Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided,
contact a qualified electrician for proper installation.
c) This seasonal use product is not intended for permanent installation
or use.
d) Do not mount or place near gas or electric heaters, fireplaces,
candles or other similar sources of heat.
e) Do not secure the wiring of the product with staples or nails, or
place on sharp hooks or nails.
f) Do not let lamps rest on the supply cord or on any wire.
g) Unplug the product when leaving the house, when retiring for the
night, or if left unattended.
h) This is an electric product-not a toy! To avoid risk of fire, burns,
personal injury and electric shock it should not be played with or placed
where small children can reach it.
i) Do not use this product for other than its intended use.
j) Do not hang ornaments or other objects from cord, wire, or light
string.
k) Do not place lighting string on carpeting, drapes, furniture, or allow
it to contact vinyl siding while the power is on.
I) Do not perform any maintenance or troubleshoot for bad or broken lamps
while the power is on.
m) Do not close doors or windows on the product or extension cords as
this may damage the wire insulation.
n) Do not cover the product with cloth, paper or any material not part of
the product when in use.
o) This product is equipped with push-in type lamps. Do not twist lamps.
p) This product employs overload protection (fuse). A blown fuse
indicates an overload or short-circuit situation. If the fuse blows, unplug
the product from the outlet. Also unplug any additional strings or products
that may be attached to the product. Replace the fuse as per the user
servicing instructions (follow product marking for proper fuse rating) and
check the product. If the replacement fuse blows, a short-circuit may be
present and the product should be discarded.
q) Read and follow all instructions that are on the product or provided
with the product.
SAVE THESE INSTRUCTIONS USE AND CARE INSTRUCTIONS
a) When the product is placed on a live tree, the tree should be well
maintained and fresh. Do not place on live trees in which the needles are
brown or break off easily. Keep the tree holder filled with water.
b) If the product is placed on a tree, the tree should be well secured
and stable.
c) Before using or reusing, inspect product carefully. Discard any
products that have cut, damaged, or frayed wire insulation or cords, cracks in
the lamp holders or enclosures, loose connections, or exposed copper wire.
d) When storing the product, carefully remove the product from wherever
it is placed, including trees, branches, or bushes, to avoid any undue strain
or stress on the product conductors, connections, and wires.
e) When not in use, store neatly in a cool, dry location protected from
sunlight.
USER SERVICING INSTRUCTIONS
Fuse replacement:
Most often, fuses blow because too many sets have been strung end-to-end.
a) Before changing fuses, make sure the set is unplugged.
b) Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
c) Using a flathead screwdriver, open fuse cover. Slide open the a:tJJ
fuse access cover on top of attachment plug towards blades.
d) Remove fuses carefully.
e) Risk of fire. Replace fuse only with 3Amp, 125 Volt fuse \ (provided
with product).
f) Close fuse cover. Slide closed the fuse access cover on top of
attachment plug. Make sure door is fully closed and fuses are completely
covered.
g) Risk of fire. Do not replace attachment plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attachment plug is
damaged.
Bulb replacement: Before changing bulbs, make sure set is unplugged.
Step 1: Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling cord.
Step 2: Hold bulb by the plastic base and pull bulb/base straight out of
socket.| 
Step 3: Replace lamp with only 3.8 volt, 0.068 watt LED type lamp
(provided with product).| 
If the spare bulbs provided with the product have no plastic base or the plastic base does not fit, first follow steps1-2above. Then
a) Remove the old bulb by straightening the bulb wires and pulling bulb
straight from the base.
b) Replace the new bulb by straightening the bulb leads and aiming each
wire into a separate hole in the plastic base.
c) Make sure each bulb lead comes out an exit opening at the bottom of
the plastic base. Now bend each lead up such that each bulb lead fits closely
against the narrow side of the plastic base.
CAUTION
-
This lighting string is rated 21.6 Watts (0.18Amps), do not overload. Connect other lighting, strings or decorative out tits end-to-end up to a maximum ol 216 Watts (1 .8Amps) total.
If connecting to a lighting string !hat does not have a Wattage (W) rating ( found on the tag within 6 inches of the plug) calculate the wattage as follows: Multiply the current LA)which is on the flag-type tag by 120.
For Example : Lighting string is rated 120 V, 60 Hz, 0.18Amps. 0.18 X 120 = 21.6 Watts.
Add the wattage of each light string together for a total of 216 Watts or less. [Do not exceed 216 Watts.) -
To reduce the risk of overheating, replace burned-out bulbs promptly. Use 3.8 volt, 0.068watt LED type lamp only.
-
To reduce the risk of fire and electric shock: a) Do not install on trees having needles, leaves or branch coverings of metal or materials which look like metal, and b) Do not mount or support strings in a manner that can cut or damage wire insulation.
Customer Support
For questions and/or assistance, call customer service at
1-877-398-7337 or visit us on the web
at www.geholidaylighting.com.
©2022 Nicolas Holiday Limited., 9F., No.37, Guangfu N Rd., Taipei, Taiwan
10560 All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>