kogan KA2ICDISPSA Ice Cube Maker and Water Dispenser User Guide
- June 9, 2024
- Kogan
Table of Contents
kogan KA2ICDISPSA Ice Cube Maker and Water Dispenser
SAFETY & WARNINGS
Ensure to read all instructions in this user guide prior to first use. Retain this user guide for future reference. Failure to follow these instructions may result in serious injury or death.
- When using the appliance, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons and property.
- This appliance can be used by children aged 8 years and above and by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
- Adult supervision is required when this appliance is used around children.
- Children are not permitted to play with the appliance.
- Cleaning and user maintenance should not be performed by children without supervision.
- This appliance is intended to be used in households and similar areas such as:
- Staff kitchen areas in shops, offices, and other working environments.
- Farmhouses and clients in hotels, motels, and other residential-type environments.
- Bed and breakfast type environments.
- Catering and similar non-retail environments.
- This appliance supports voltages between 220–240V with a frequency of 50Hz.
- Ensure the appliance is placed away from direct sunlight and there is at least a 15cm clearance on all sides. This will ensure there is enough air circulation around the appliance.
- Keep ventilation openings clear of obstructions.
- Ensure the appliance is used on a dry, flat surface.
- The gas inside the appliance is flammable.
- Connect this appliance to properly grounded outlets only. No other appliance should be plugged into the same outlet. Improper use of the grounded plug can result in an electric shock.
- When in use, ensure the plug is fully inserted into the socket.
- If the power cord is damaged, stop use immediately and contact help.Kogan.com for assistance.
- This appliance must be positioned in such a way that the plug is accessible.
- Do not run the power cord over the carpet or other heat insulators.
- Do not cover the power cord.
- Keep the power cord away from traffic areas and do not submerge in water.
- Use of an extension cord is not recommended as it may overheat and present a risk of fire. If an extension cord is used, use a cord with a minimum wire gauge of 0.75mm and is rated at least ~16A/250V with a plug.
- Unplug the appliance before cleaning or servicing.
- Do not use the appliance outdoors.
- Do not use liquids other than water to make ice cubes.
- Do not clean the appliance with flammable liquids. The fumes can lead to a fire hazard or explosion.
- Do not tip over the appliance.
- If the appliance is brought in from outside during winter or from any other cold environment, wait for a few hours to allow the appliance to warm to room temperature before plugging it in.
- Do not store explosive substances (for example, aerosol cans with a flammable propellant) in this appliance.
- WARNING: Risk of fire/flammable materials used. Follow local regulations regarding the disposal of the appliance as it has flammable blowing gas.
- Do not damage the refrigerant circuit.
- Do not use mechanical devices or other means to accelerate the defrosting process or ice-making process.
- Do not use any third-party devices with this appliance.
OVERVIEW
- Evaporator
- Control panel
- Side door
- Water tank
- Drip tray
- Drip tray cover
- Ice cube pushing spring
- Top window
- Drain plug
- Air outlet
- Display
- Timer button
- Select button
- Ice dispensing button
- Water dispensing button
- Power button
- Timer indicator
- Small ice cube indicator
- Large ice cube indicator
- Ice dispensing indicator
- Power indicator
- Full indicator
- Low water level indicator
- Error indicator
- Water dispensing indicator
BEFORE FIRST USE
Remove the packaging and ensure all components are accounted for. Remove the
protective tape on the appliance then open the top window and take out the
drip tray and drip tray cover. If any components are missing, contact
help.Kogan.com for assistance.
It is strongly recommended to clean the appliance before first use.
- Pour a solution of diluted detergent and warm water into the water tank then use a soft cloth to clean the interior.
- Rinse the interior with water then unplug the drain plug located at the bottom of the appliance to allow the water to flow out.
- Wipe the exterior with a solution of mild detergent and warm water.
- Dry the interior and exterior with a soft cloth.
Placement
- Place the appliance on a dry flat area away from direct sunlight and other sources of heat (for example, stoves).
- To avoid overheating, ensure there is at least a 15cm clearance around all sides of the appliance.
- Allow the refrigerant to settle for one hour before plugging in the power cord.
OPERATION
Filling and powering
-
Place the drip tray and drip tray cover onto the appliance. Open the side door and fill water (7°C–32°C) into the water tank until just below the ‘MAX’ line
-
Ensure you have allowed the refrigerant to settle for one hour. Plug the power cord into a grounded wall outlet. The power indicator ‘ ’ on the display will then begin flashing.
Note:
Ensure the socket is easily accessible. -
Press the power button on the control panel. The power indicator ‘ ’ on the display will then turn solid, and the large ice cube indicator ‘ ’ will begin flashing. The appliance will then begin making ice.
Note:
If the full indicator is illuminated, this indicates the appliance is full of ice and will stop operating automatically.
Adjusting the ice cube size
By default, the appliance will form large ice cubes. If you would like small
ice cubes, press the select button on the control panel. The small ice cube
indicator ‘ ’ will then illuminate, enabling the appliance to form small ice
cubes.
If both sizes are not suitable, press and hold the power button for 5 seconds
whilst the appliance is making ice. ‘0’ will appear on the display. This
indicates the appliance is set to the default ice-making times.
Press the select button to activate the display to cycle between showing ‘1’
and ‘2’. Based on the currently set ice cube size, this will add the
respective number of minutes to the ice cube making times, hence changing the
size of the ice cubes made. After 5 seconds, the ice cube making time will be
saved and the numbers will disappear.
Ice-making cycles can range from 6–12 minutes.
Dispensing ice cubes
- Place a container (not included) onto the drip tray cover.
- Press the ice dispensing button on the control panel. The ice dispensing indicator ‘ ’ on the display will then illuminate and the ice cube pushing spring will start rotating to push ice cubes out of the appliance.
- To stop dispensing, press the ice dispensing button again.
Dispensing water
- Place a cup (not included) onto the drip tray cover.
- Press the water dispensing button on the control panel. The water dispensing indicator ‘ ’ will then illuminate and water will begin dispensing from the appliance.
- After 10 seconds, the appliance will automatically stop dispensing water.
Adjusting the water dispensing time
To adjust the amount of time the appliance dispenses water, press and hold the
water dispensing button for 5 seconds. The display will show ‘10s’.
Press the select button to adjust the dispensing time (can be adjusted to be
between 7–25 seconds). This will be reflected on the display. Once set, wait
for 5 seconds to allow the appliance to save the desired dispensing time.
Activating the timer
- If the appliance is running, you may set up a timer for the appliance to stop operating after a certain time.
- If the appliance is on standby, you may set up a timer for the appliance to start running after a certain time.
- The default time is 1 hour. Press the timer button to activate the timer.
Cancelling the timer
Press the timer button to cancel the timer. The time and ‘H’ on the timer
indicator will disappear.
Adjusting the time set on the timer
- Ensure the timer has not been activated. Press the timer button.
- Press the select button to increase the timer by 30-minute increments. Pressing the select button repeatedly will result in larger time increment increases.
During this adjustment, the ‘H’ on the timer indicator will be flashing. Once the desired time has been set, wait for 5 seconds to allow the appliance to save the desired time. The ‘H’ on the timer indicator will then turn solid. After this, the timer will be activated.
Note:
The timer can be set from 30 minutes up to 19 hours.
Powering off
Press the power button to turn the appliance off.
Draining water
Before cleaning the appliance or changing the water, the water inside the
appliance must first be drained out.
Unplug the drain plug from the bottom of the appliance and allow the water to
flow out. You may also connect a soft plastic tube to help guide the water
out.
Notes:
- To maintain hygiene, the water must be changed every 24 hours.
- If the appliance will not be used, drain the water and dry the water tank.
Refilling
The water level should be checked regularly. If there is insufficient water,
the appliance will stop operating automatically. The low water level indicator
‘ ’ will illuminate to indicate more water is required.
- Press the power button to turn the appliance off.
- Open the side door and fill water up to just below the ‘MAX’ line. Allow the refrigerant inside the appliance to cool for at least 3 minutes.
- Press the power button again to turn the appliance on and resume use.
CLEANING & CARE
Ensure the appliance is turned off, the power cord is unplugged, and water is drained before cleaning.
- Pour a solution of warm water with diluted detergent into the water tank and the space below the transparent window inside, then use a soft cloth to wipe the interior.
- Use water to rinse the interior and drain out the water by unplugging the drain cap on the bottom of the appliance.
- Clean the exterior with a solution of mild detergent and warm water.
- Dry the interior and wipe the exterior with a soft cloth.
TROUBLESHOOTING
| Problem | Possible cause | Solution |
|---|---|---|
| The low water level indicator ‘ ’ is illuminated and the arrow is flashing. |
The water tank is low on water.
| ****
Turn off the appliance, then fill it with water and press the power button again to restart the appliance.
The full indicator ‘ ’ is illuminated and the ‘F’ is flashing.
| There is too much ice.| Remove some ice from the appliance.
There may be an obstruction inside the appliance affecting the internal
sensor.| ****
Remove the obstruction and clean the appliance.
The following error indicator is illuminated:| The ambient temperature sensor has broken.| ****
Stop use immediately and contact
help.Kogan.com for assistance.
The following error indicator is illuminated:| ****
The appliance is not resetting properly.
| ****
Stop use immediately and contact
help.Kogan.com for assistance.
The following error indicator is illuminated:| ****
There is too little water in the water tank.
| ****
Refill the water tank.
---|---|---
The ice cubes are sticking together.
| ****
The ice-making cycle is too long.
| · Turn off the appliance and restart it after the ice cubes melt.
· Adjust the ice cube size to small.
The temperature of the water in the tank is too low.| ****
Change the water in the tank. The water should be between 7°C–32°C.
Ice cubes are not being dispensed after pressing the ice dispensing button.|
The shaft for the ice cubes is blocked.
| ****
Wait for 3 seconds then press the ice dispensing button again.
The appliance is running but unable to make ice.
| ****
The ambient temperature of the water is too high.
| · Ensure the appliance is not operating at over 32°C.
· Pour colder water into the water tank.
The refrigerant has leaked.| Stop use immediately and contact
help.Kogan.com for assistance.
The pipe in the cooling system is blocked.| Stop use immediately and contact
help.Kogan.com for assistance.
Disposal
This marking indicates that this appliance should not be disposed of with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
SPECIFICATIONS
- Compressor R600a/23g
- Operating temperature 10°C–43°C
- Power supported 220–240V, 50Hz
- Current (when making ice) 0.8A
- Current (when dispensing ice) 1.0A
- Net weight 9.5kg
- Vesicant C5H10
DIAGRAM
Need more information?
We hope that this user guide has given you the assistance needed for a simple
set-up. For the most up-to-date guide for your product, as well as any
additional assistance you may require, head online to
help.kogan.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>