JAMARA Bentley EXP12 Ride-on Bentley Instructions

JAMARA Bentley EXP12 Ride-on Bentley

General information

JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.

Suitable for children over 3 years.

Warning : Not suitable for children under 36 months. RISK OF SUFFOCATION. Contains small parts which can be swallowed. Keep away necessarily from children

• Before playing, remove all protective films from all parts (e.g. mirrors, logos………)
• This product is not intended for use by individuals (including children) with reduced physical, sensory or mental capabilities or lack of experience and / or knowledge.
• Due to its top speed this toy is not suitable for children under 3 years!
• Minimum age: 3 years (Depending on development, a minimum age of 4 years could be appropriate), Maximum weight: <30 kg

Before assembly

• Adult required for assembly. Keep children away while assembling.
• Tools (not included) needed for assembly: screwdriver

Certificate of Conformity

Hereby JAMARA e.K. declares that the product “Bentley EXP12, No. 460333, 460334“ complies with Directive 2014/30/EU, 2014/35/EU, 2011/65/EU und 2009/48/EC. The full text of the EU Declaration of Conformity is available at the following Internet address: www.jamara-shop.com/Conformity

• Read the complete instructions and security instructions carefully before using the model.
• To prevent accidents and injuries, DO NOT leave your Child unattended during operation of the vehicle. Never let your Child out of your sight while the driving a vehicle
• DO NOT use the vehicle on public roads or places or other dangerous locations. ONLY operate the Ride On Car in places such as private parking, private land or other safe locations. Make sure that no person or animal is endangered
• The model stops after releasing the accelerator, independently on a horizontal surface. The vehicle has no brake or parking brake. Do not operate the vehicle uphill or downhill, and secure it when parking

DANGER.

• For safe driving, you should make sure that your Child understand and adheres to the following rules:
  • Always sit tight, do not get up during the ride.
  • Never take additional Children for a ride. (The vehicle is only suitable for 1 person)
  • Hold tight.
  • Never drive without shoes.
  • Never drive in the dark.
• Keep hands, hair, loose clothing and any other item away from any rotating parts.
• The Model should not be used in rooms or halls with high humidity (for instance g arages), in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.
• The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil

OVERVIEW

1| Chassis| 6| Washer Ø 12 mm 6x| 11| Machine screw M5 x 16 mm 2x| 16| Nut Ø 5 mm
---|---|---|---|---|---|---|---
2| Gearbox 2x| 7| Motor hood 2x| 12| Seat| 17| Windshield
3| Driving wheels 2x| 8| Screw Ø 4 X 12 mm 8x| 13| Rearview mirror 2x| 18| Spanner 2x

4| Front wheel 2x| 9| Nut 4x| 14| Steering wheel| 19| Charger
5| Bushing 2x| 10| Hubcap 4x| 15|  Safety pin M5 x 40| |

Assembly of the rear wheels

• Place the body with the underside facing up.
• Place the gearbox (2) on the rear axle.
• Now attach a drive wheel (3) to the gear unit.
• Slide a washer (6) onto the rear axle.
• Fix the whole thing with a lock nut (9). Tighten the nut with a spanner.
• Finally, put a cover (10) on the wheel
• Repeat this on the other side.

Assembly of the front wheels

• To mount the front wheels, slide a washer (6) onto the front axle.
• Attach a wheel (4) including bearing bush (5) and slide a washer (6) onto the axle.
• Fix the whole thing with a lock nut (9). Tighten the nut with a spanner.
• Finally, attach a cover (10). Repeat the steps to mount the other wheel.

Gearbox connection

Pay attention to the installation direction when installing the gear units (L = left, R = right), connect the gearbox connections to the connections in the model. The choice of connection has no effect on the direction of rotation of the gear units. Only connect connectors that fit into each other.

Battery connection

Connect all connectors as shown. Only plug matching connectors into eachother and be sure not to reverse the polarity. Make sure the red wire is well connected with the red terminal on the battery, and same as the black one.

Steering wheel assembly

Open the battery cover. Put 2 AA batteries making sure that it is corectly put in. Then close the cover. Install the steering wheel (14) in the Intended position and secure it with the Safety pin (15) and nut (16)

Battery warning:

• Non-rechargeable batteries are not to be recharged!
• Do not open!
• Do not dispose of in fire!
• Do not mix old and new batteries!
• Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
• Rechargeable batteries are to be removed from the toy before being charged!
• Rechargeable batteries are only to be charged under adult supervision!
• The supply terminals are not to be short-circuited

Attach the Motor Hood

Fit the Motor hood (7) on the motor. Tighten four screws (8) to secure it. Reapeat the abouve for the other motor hood

Attach Seat

• Position the seat (12) over the vehicle body.
• Tighten two screws (11) with a screwdrive

Attach the Windshield
Insert the tabs on the windshield (17) in the slots on the vehicle body, push until you hear it click into place.

Attach the view mirrors
Install wing mirror (13) to the designated position, and fasten it.

Charging Your Vehicle

• The power swich must be turned in OFF position when charging.
• Insert the charger (4) into the socket – the LED lights up green. Connect the charger to the charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED lights green again, the battery is fully charged.
• The charge time is between 8 and 12 hours.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.

Only use in direct supervision of an adult!

To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.

Functions

1. ON/Off switch

2. Shift Lever

3. Forward: Press the “Forward-backward switch” on the “Forward” position.

4. Press the “Foot pedal”, the model drives forward.

5. Reverse: Press the “Forward-backward switch” on the “Backward” position.

6. Press the “Foot pedal”, the model drives backward.
   IMPORTANT! Always stop vehicle when changing the direction to avoid damage the gears and motor.

7. Sounds buttons

8. Speed

9. High speed – Fast speed

10. Low speed – Slow speed

11. Foot pedal To move the car, press the pedal down.

12. To brake or slow down, release pressure from the pedal.

Danger!

Always switch off the model immediately after each use. Immediately after each use, the batteries should be disconnected from the model. The batteries can be deeply discharged by leaving them switched on accidentally or leaving them plugged in. Due to deep discharge, the batteries lose power or can be damaged to such an extent that charging or discharging is no longer possible or the batteries can self-ignite during the charging or discharging process (fire hazard). Never attempt to charge or discharge deeply discharged batteries. The voltage of a battery should never fall below 5.7 volts to avoid a deep discharge. The fully charged battery has a voltage of approx. 6.5 volts. After use, the intact batteries should be fully charged immediately after a cooling phase of min. 10 minutes but at the latest after 12 hours to avoid a subsequent deep discharge by selfdischarge. If the batteries are not used or stored for a longer period of time, the batteries should be checked for voltage (min. 6.2 volts) or damage at least every 3 months and recharged or disposed of if necessary

Troubleshooting

The vehicle does not run

• The battery may low on power. After each use, or once a month minimum, charge the battery. Do not leave the battery on the charger for more than 15 hours.
• Cables are not connected properly (refer to page 4, battery connection)
• Electric system is damaged.

Water may have corroded the system, or loose dirt, gravel or sand might have jammed the switch.
If your problem could not yet be solved, you will find further problem solutions and the corresponding spare parts on our homepage (www.jamara- shop.com) under article number 460333.

Disposal restrictions

Batteries and accumulators must not be disposed of in domestic waste. You are obliged to dispose of batteries (seperate collection) appropriately. After use you can return batteries free of charge to the retail store. As batteries contain substances that can be irritant, can cause allergy and are highly reactive, separate collections and proper recycling is important to the environment and to your health. If the batteries are marked with a chemical symbol Hg, Cd or Pb below the crossed-out waste bin on wheels it refers to that more than 0.0005% of mercury (Hg), more than 0.002% of cadmium (Cd) or more than 0.004% Lead (Pb) is included.

JAMARA e.K.
Inh. Manuel Natterer
Am Lauerbühl 5 – DE-88317 Aichstetten
Tel. +49 (0) 75 65/94 12-0
Fax +49 (0) 75 65/94 12-23
info@jamara.com
www.jamara.com
Service – Tel. +49 (0) 75 65/94 12-777
service@jamara.com

References

• jamara.com
• Jamara Germany - RC model making & toys online shop Ride On Cars
• jamara.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>