GE Lighting 78241 StayBright LED Flickering Window Candle User Guide
- October 28, 2023
- GE Lighting
Table of Contents
GE Lighting 78241 StayBright LED Flickering Window Candle
USE AND CARE INSTRUCTIONS
The instructions below should be followed for proper use and care of this product:
- Do not expose candle to moisture.
- Not for outdoor use.
- Replace only with (2) AA Alkaline batteries.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Install (2) AA Alkaline batteries as shown (FIG.1).
- Remove batteries from product when not in use for an extended period of time.
- Remove used batteries promptly.
- Turn light ON/OFF as shown (FIG.2).
To install batteries:
- While holding the candle base with one hand, CAREFULLY pull candle upward out of the cup with the other hand.
- Turn cap counterclockwise to open battery cavity.
- Insert (2) AA Alkaline batteries, positive (+) end first.
- Replace cap and put candle back in the cup by pushing down.
Troubleshooting
| PROBLEM | POSSIBLE CAUSE | CORRECTIVE ACTION |
|---|---|---|
| If the product does not light |
- The product is not turned on.
- Batteries assembled incorrectly.
- Low power or dead batteries.
|
- Rotate window candle clockwise in base.
- Follow battery installation procedure.
- Replace with new batteries
This Class B digital apparatus complies with Canadian ICES-3(B) / NMB-3(B).
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Customer Support
For indoor use only
GE is a trademark of General Electric Company and is under license by Nicolas
Holiday Limited
Made in China
©2022 Nicolas Holiday Ltd. 204 Spring Hill Road Trumbull, CT 06611
9F., No. 37, Guangfu North Rd. Taipei, Taiwan 10560 All rights reserved.
For additional GE Holiday Lighting information, please visit us on the web at
www.geholidaylighting.com
