Schreder Bora Explora Gen2 Modern Lighting Bollard Instruction Manual
- June 3, 2024
- Schreder
Table of Contents
Bora Explora Gen2 Modern Lighting Bollard
Instruction Manual BORA EXPLORA GEN2
Installation instructions
Bora Explora Gen2 Modern Lighting Bollard
BORA EXPLORA GEN2 INSTALLATION KIT
BORA EXPLORA GN2 1×8 LEDs
BORA EXPLORA GN2 2×8 LEDs
SAFETY INSTRUCTIONS
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person.
Always switch off the power prior to installation, maintenance or repair
activities.
RISK GROUP 2 – CAUTION! Hazardous optical radiation may be emitted from this
product. Do not stare at the luminaire when operating as it may be harmful to
the eyes. The luminaire should be positioned so that prolonged staring at the
luminaire at a distance of less than 0.44m is not expected.
In case of PVC insulated mains cable, the installer MUST ensure that the WHOLE
cable is protected against climatic conditions, especially UV rays and rain,
by making sure that the cable is contained inside the luminaire and pole
Y-connection: In case of damage to the wire, it has to be replaced only by
the manufacturer, distributor or by an expert, to avoid risks.
Copyright © Schréder S.A. 2018
– Executive Publisher: Stéphane Halleux
– Schréder International Services S.A.
– B-4000 Liége, Rue de Mons 3 (Belgium)
– The information, descriptions and illustrations herein are only of an
indicative nature and subject to changes without notice.
02-54-351 | DOC-0019692 revC | 09-2021
www.schreder.com