VICTROLA VSC-725SB Portable Bluetooth Turntable Instruction Manual

VICTROLA VSC-725SB Portable Bluetooth Turntable

OVERVIEW

RECORD HOLDER LID

SIMPLE SETUP

GETTING STARTED
Remove the needle cover, by gently pulling towards the front of the unit.C arefully plug in the unit and remove any accessories from the platter.

Note: It is recommended that this product should be operated only from the type of power source indicated on the power adaptor.

BASIC OPERATION

Push the PowerNolume dial upward to turn the unit ON. Slide the Function Switch to select the following playing modes:

• VINYL : Play a Vinyl record.
• VINYL STREAM : Connect to an external Bluetooth speaker or headphone.
• BLUETOOTH : Connect and play music from a Bluetooth device (smartphone, etc).
• VOLUME : Slide to raise or lower the volume.
• RCA LINE OUT ; Use the red & white plugs on the back of the unit to connect to an amplifier/stereo device. Be sure to first reduce the volume to a minimum level on the record player.
• HEADPHONE: Use the headphone jack on the back of the unit to connect your headphones/earbuds. Be sure to first reduce the volume to a minimum level on the record player.

VINYL PLAYING

VINYL : Playing a vinyl record When the unit is powered ON, slide the Function Switch to Vinyl mode. The LED Indicator Light will turn RED and remain lit Remove the needle cover, by gently pulling towards the front of the unit.S elect the proper record speed. If using a 45 RPM record, use the included 45 adaptor. Release the tone arm from the holder and gently place on the record using the lift lever. Slide the Volume Dial to adjust the volume.

Note: -Make sure to only touch the center or edges of the record to avoid damage to the vinyl grooves. If no sound is playing, the unit may be in Vinyl Stream mode, adjust the Function Switch to make sure it is in Vinyl mode.

Auto and Manual Stop Selection SWitch : If this switch is turned ON, the record will start spinning when the tone arm moves over the record and the record will stop automatically when playback is finished. If this switch is OFF, the record will automatically begin to spin when the unit is in “VINYL.’.’ function mode and the record will continue to spin after playback is finished

VINYL STREAM

VINYL STREAM:
Listen to a vinyl record on a external Bluetooth speaker or headphones. When the unit is powered ON, slide the Function Switch to Vinyl Stream mode. The LED Indicator Light will turn RED and flash.Tu rn ON your external Bluetooth speaker or headphone, and set to pairing mode. Wait a few seconds for the unit to find your device When connected the unit will chime and the LED light will remain RED. Follow the proper steps to play a vinyl record in the “Vinyl” section above. Use your external device to control the volume.

Note:

• In Vinyl Stream mode, internal speakers wiJ/ be disengaged.
• We recommend placing the Bluetooth device within 1m (3.3′) of the product when initially pairing.
• Make sure the unit is within 10m (33ft) from your external device for the strongest connection.
• Vinyl Stream is only compatible with vinyl record playback.
• The product stays in the pairing mode for 30 seconds. If pairing is not properly completed, follow the above steps again from the beginning after turning all devices OFF.

BLUETOOTH PAIRING

BLUETOOTH: Connecting and playing music from an Bluetooth device (Smartphone). When the unit is powered ON, slide the Function Switch to Bluetooth mode. The LED Indicator Light will turn BLUE and flash. On your device, turn Bluetooth ON. Then search for and select “VICTROLA RE-SPIN” in the settings menu. When connected, the unit will chime and the LED light will remain blue. Use your external device to control playback.

Note : -Make sure the unit is within 10m (33ft) from your external device for the strongest connection.

HOW TO REPLACE THE TURNTABLE STYLUS (Replacement Stylus# VND-08)
Removing the Stylus from the Cartridge

1. Using your fingers, hold at point “A” and push down point “B”
   WARNING : When applying force to stylus, too much may damage or break the stylus.

2. Continue to push down until the stylus separates from the front of the cartridge.

3. Remove the rear of the stylus carefully from the cartridge.

Installing the Stylus
Follow the previous steps but in reverse

Caution:

• Do not remove or bend the stylus needle.
• Do not touch the needle to avoid injury to your hand.
• Turn off the unit’s power before you replace the stylus.
• Keep out of reach of children.

Please note : The stylus should last about 50 hours under normal use. ft is recommended that the stylus be replaced as soon as you notice a change in sound quality

SPECIFICATIONS

GENERAL

• Power Adaptor …………………………………….. 12V/1.5A
• Power Consumption …………………………………. 10W
• Power Output …………………•…•……………….1 x 1O W
• Operating Temperature ……………………………….. – 5°C – 40°C

RECORD PLAYER
Speeds ………………………………………….. 33-1/3, 45 & 78 RPM

BLUETOOTH

• Bluetooth Version …………………………………… Bluetooth V 5.2
• Bluetooth Profile ……………………………………. A 2DP, AVRCP
• Bluetooth Frequency Range ……………………………. 2.40GHz-2.4BOGHz
• Operating Distance ………………………………….. 10 meters (33 ft.)

ADAPTOR

• Manufacturer …..•…………….•…•………………. Shenzhen Guangkaiyuan Technology Co Ltd
• Model …………………………………………… GKYZB 015 012 0UL

INCLUDED:
Re-Spin with Removable Lid, Power Adaptor, 45 RPM Adaptor, Instruction Manual

WARNINGS

• Always follow basic safety precautions when using this appliance, especially when children are present.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not damage the power cord, neither do not place any heavy objects on it, do not stretch it or bend it. Also do not attach extension cables. Damage to the power cord may occur fire or electric shock.
• If the supply cord is damaged, it must be replaced by the manufacturer, a service agent or similarly qualified persons in order to avoid a hazard.
• Ensure that the unit plugged into an AC 100-240v 50/60Hz power outlet. Using higher voltage may cause the unit to malfunction or even catch fire.
• If the power plug does not fit into your outlet, do not force the plug into an electrical socket if it does not fit.
• Turn off the unit before unplugging it from the power source to completely switch it off.
• Do not disconnect or connect the power cord with wet hands.I t may cause an electrical shock.
• Ensure that the main plug is always easily accessible.
• This product does not contain any parts that are serviceable by the user. In case of a fault, contact the manufacturer or authorized service department. Exposing the internal parts inside the device may endanger your life. The manufacturers guarantee does not extend to faults caused by repairs carried out by the unauthorized third parties.
• Ensure this product is used in moderate climates only (not in tropical/subtropical climates).
• Place product on a flat, stable surtace that is not subject to vibrations.
• Ensure the product and its parts are not overhanging the edge of the supporting furniture.
• To reduce the risk of fire, electric shock or damage to this product, do not expose it to direct sunlight, dust, rain and moisture. Never expose it to dripping or splashing and do not place objects filled with liquids on or near the product.
• Do not place objects filled with liquids, such as vases, on the apparatus.
• Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
• Do not place the product where the humidity is high and ventilation is poor
• Do not mount this product on a wall or ceiling.
• Do not place the unit near TV’s, speakers and other objects that generate strong magnetic fields.
• Do not leave 1he unit unattended when in use.
• Allow at least 30cm clearance from the rear and the top of the unit and 5cm from each side. Always ensure that the ventilation openings are not covered with items such as newspapers, tablecloths, curtains, etc.
• NEVER let anyone, especially children, push anything into holes, slots or any other openings in the unit’s casing as this could result in a fatal electric shock.
• Storms are dangerous for all electric appliances. If the main or aerial wiring is struck by lighting, the appliance might get damaged, even if it turned off. You should disconnect all the cables and connectors of the appliance before a storm.
• Excessive sound pressure from headphones can cause hearing loss.
• Do not cover ventilation openings, this is not intended to be used on soft support.

MAINTENANCE:

• Unplug the power cable from the power source before cleaning the appliance.
• Use a soft clean rag to clean the outside of the unit. Never clean it with chemicals or detergent.

SAFETY INSTRUCTIONS

POWER ADAPTER;

• To disconnect the unit from the main supply, unplug the lead from the main socket.
• Only use the supplied main adapter, as failure to do this may result in a safety risk and/or damage to the unit.
• The main plug of power adapter is used as the disconnect device. The socket-outlet shall be installed near the equipment and shall be easily accessible.

TO PREVENT FIRE OR SHOCK HAZARD. DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Please read these safety instructions and respect the following warnings before the appliance is operated

• AC Voltage
• DC Voltage
• Class II equipment
• For indoor use only
• Energy Efficiency marking with level VI
• Polarity of D.C power connector
• The shown above appears on electrical and electronic equipment (or the packaging) to remind users of this.
• Users are requested to use existing return facilities for used equipment and batteries.

FCC WARNINGS

FCC STATEMENTS
Caution: the user is cautioned that charges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful in1erference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE;
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. However, there is no guarantee that interterence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interterence by one of more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

FCC & IC RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

WARRANTY

Victrola (Innovative Technology Electronics, LLC) warrants to the original retail purchaser that this product will be free from defective materials and workmanship for one (1) year from the date of purchase, subjectto the limitations below. This warranty period is not extended if we replace the product. To obtain a replacement under the terms of this warranty, you must contact the dealer from which it was purchased with your original receipt. If assistance from the dealer from which it was purchased is impossible, you may contact our customer service for warranty assistance at victrola.com/contact. Except as limited below, if the product proves defective in either material or workmanship within one (1) year from the date of purchase, Victrola will replace the product at no charge. If the product model is no longer available and cannot be replaced with an identical model, Victrola will issue a merchandise credit for the purchase price to be redeemed at victrola.com.

Limitations:

• This limited warranty does not cover failure of the product arising, in whole or in part, from improper installation, storage, transportation, misuse, abuse, accident, neglect, mishandling, unauthorized repair, modification, or wear from ordinary use or environmental deterioration.
• This limited warranty does not cover cosmetic damage, including paint damage, or consequential damage to other components or premises which may result for any reason from the failure of the product.
• This limited warranty is null and void for products not used in accordance with Victrola’s instructions.
• This limited warranty terminates if the original retail purchaser sells o otherwise transfers this product.
• This limited warranty is null and void for defects or damage caused by installation or repair performed by any person or entity other than a Victrola authorized installer or dealer.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state, jurisdiction to jurisdiction or country to country. All express and implied warranties for the product , including but not limited to any implied warranties of merchantability and fitness for a particular purpose, are limited in time to the term of this warranty. Some states, jurisdictions or countries do not allow the exclusion of certain implied warranties or conditions, or limitations on how long an implied warranty or condition lasts, so this limitation may not apply to you. Victrola’s responsibility for malfunctions and defects in hardware is limited to replacement or repair as set forth in this warranty statement Victrola does not accept liability for special, punitive, consequential or incidental damages or losses, whether direct or indirect, including without limitation, any liability for third party claims against you for damages or losses or for products not being available for use. The maximum liability for which Victrola may be responsible will be no more than the amount you paid for the product that is the subject of the claim. Some states, jurisdictions or countries do not allow the exclusion or limitation of special, indirect, incidental or consequential damages, so the above limitation or exclusion may not apply to you.

Canada and US Territories
The Warranty on this product shall comply with applicable law when sold to a consumer in Canada or a US Territory. To obtain any applicable warranty service, please contact the dealer from which you purchased the product, or the distributor that supplied 1he product, with your original receipt If assistance from the dealer from which it was purchased is impossible, you may contact our customer service for warranty assistance at victrola.com/contact If this product proves defective in either material or workmanship, Victrola will replace the product at no charge. If the product model is no longer available and cannot be repaired effectively or replaced with an identical model, Victrola at its sole option may replace the unit with a current model of equal or greater value.

Outside the U.S, Canada, and US Territories
The Warranty on this product shall comply with applicable law when sold to a consumer outside of the United States, Canada, and US Territories. To obtain any applicable warranty service, please contact the dealer from which you purchased the product, or the distributor that supplied the product, with your original receipt

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>