kvm-tec Industryline 24V Smart Connections 6701i Set Industryline MVXi In Copper Installation Guide
- June 3, 2024
- kvm-tec
Table of Contents
kvm-tec Industryline 24V Smart Connections 6701i Set Industryline MVXi In
Copper Installation Guide
Delivery Content
LOCAL/CPU Unit
- 1 x MVX1i local (CPU) without power supply
- 1 x Power Connector
- 1 x DVI – DVI cable 1,8m/5,9ft
- 1 x USB cable 1,8m/5,9ft
- 1 x VGA -DVi cable ,8m/5,9ft (opt)
- 4 x rubber feet
REMOTE/CON Unit
- 1 x MVX1i remote (CON) without power supply
- 1 x Power Connector
- 4 x rubber feet
kvm-tec upgrades included
- Matrix Switching System up to 48 endpoints
- USB Memory,
- Analogue VGA-transmitted as DVI
Quick Installation
INDUSTRYLINE MVXi local / CPU – remote/ CON
- Connect the CON / Remote and the CPU / Local Unit to the included 12V 1A power supply.
- Now connect the USB cable to a USB port on your PC and connect the other end of the USB cable to the CPU / Local Unit. Connect keyboard and mouse to the CON / Remote Unit.
- Connect the CPU / Local and the CON / Remote Unit with a network cable.
- Now connect the HDMI-DVI cable to the DVI socket of the PC and the other end to the HDMI socket of the CPU / Local Unit (PC-in). Then connect the monitor with the HDMI-DVI cable to the CON / Remote Unit.
HAVE FUN – your kvm-tec Extender is now in use for many years ( MTBF approx 10 years)
No Power (No LED)| USB is not working| No Video| Video error
(stripes in the picture)
---|---|---|---
Check the powerplug| Are the USB Devices plugged in correctly?| Check if all
cables are plugged in correctly| Check if all cables are plugged in correctly
Is the power supply ok? Try another Unit.| Is the USB cable on the Local side
plugged into the PC?| Check if the PC is sending a Image by plugging in a
monitor on the local out of the local Unit| Check if the PC is sending a Image
by plugging in a monitor on the local out of the local Unit
Try reprogramming the Unit by using a JTAG programmer| Are the USB Devices
working directly on the PC?| Check if the DDC is set correctly (in menu under
point „O“)| Check if the DDC is set correctly (in the menu under point „o“)
Contact kvm-tec support| Replace the USB cable from PC to the Local Extender|
Check if both Units have the correct firmware| Check if local and remote Unit
have the correct firmware
| Check if local and remote Unit have the same firmware| Contact kvm-tec
support| Check if the network switch is setup correctly and has enough
bandwidth
| Check if the local or the remote Unit is causing the problem by swaping
first the local and than the remote Unit to another Unit| | Check if other
units have the same behaviour
| Contact kvm-tec suppor| | Contact kvm-tec support
kvm-tec Support
Check out our Installation Channel:
support@kvm-tec.com
Phone: +43 2253 81912 – 30
We are here for you to answer your questions about installation?
Manual download www.kvm-tec.com or kvm-tec
Installationchannel on our homepage personally +43 2253 81912
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>